mirror of
https://github.com/edk2-porting/linux-next.git
synced 2024-12-24 13:13:57 +08:00
3f1c6ebf57
The bindings describes a case where MMC/SD/SDIO slot directly connected to a SPI bus. Such setups are widely used on embedded PowerPC boards. The patch also adds the mmc-spi-slot entry to the OpenFirmware modalias table. Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com> Cc: David Brownell <david-b@pacbell.net> Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org> Cc: Kumar Gala <galak@gate.crashing.org> Cc: Grant Likely <grant.likely@secretlab.ca> Signed-off-by: Andrew Morton <akpm@linux-foundation.org> Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
24 lines
725 B
Plaintext
24 lines
725 B
Plaintext
MMC/SD/SDIO slot directly connected to a SPI bus
|
|
|
|
Required properties:
|
|
- compatible : should be "mmc-spi-slot".
|
|
- reg : should specify SPI address (chip-select number).
|
|
- spi-max-frequency : maximum frequency for this device (Hz).
|
|
- voltage-ranges : two cells are required, first cell specifies minimum
|
|
slot voltage (mV), second cell specifies maximum slot voltage (mV).
|
|
Several ranges could be specified.
|
|
- gpios : (optional) may specify GPIOs in this order: Card-Detect GPIO,
|
|
Write-Protect GPIO.
|
|
|
|
Example:
|
|
|
|
mmc-slot@0 {
|
|
compatible = "fsl,mpc8323rdb-mmc-slot",
|
|
"mmc-spi-slot";
|
|
reg = <0>;
|
|
gpios = <&qe_pio_d 14 1
|
|
&qe_pio_d 15 0>;
|
|
voltage-ranges = <3300 3300>;
|
|
spi-max-frequency = <50000000>;
|
|
};
|