mirror of
https://github.com/edk2-porting/linux-next.git
synced 2024-12-22 20:23:57 +08:00
c8307106f5
Add device tree bindings for the DMA controller on JZ4780 SoCs, used by the dma-jz4780 driver. Signed-off-by: Alex Smith <alex.smith@imgtec.com> Signed-off-by: Zubair Lutfullah Kakakhel <Zubair.Kakakhel@imgtec.com> Signed-off-by: Vinod Koul <vinod.koul@intel.com>
57 lines
1.7 KiB
Plaintext
57 lines
1.7 KiB
Plaintext
* Ingenic JZ4780 DMA Controller
|
|
|
|
Required properties:
|
|
|
|
- compatible: Should be "ingenic,jz4780-dma"
|
|
- reg: Should contain the DMA controller registers location and length.
|
|
- interrupts: Should contain the interrupt specifier of the DMA controller.
|
|
- interrupt-parent: Should be the phandle of the interrupt controller that
|
|
- clocks: Should contain a clock specifier for the JZ4780 PDMA clock.
|
|
- #dma-cells: Must be <2>. Number of integer cells in the dmas property of
|
|
DMA clients (see below).
|
|
|
|
Optional properties:
|
|
|
|
- ingenic,reserved-channels: Bitmask of channels to reserve for devices that
|
|
need a specific channel. These channels will only be assigned when explicitly
|
|
requested by a client. The primary use for this is channels 0 and 1, which
|
|
can be configured to have special behaviour for NAND/BCH when using
|
|
programmable firmware.
|
|
|
|
Example:
|
|
|
|
dma: dma@13420000 {
|
|
compatible = "ingenic,jz4780-dma";
|
|
reg = <0x13420000 0x10000>;
|
|
|
|
interrupt-parent = <&intc>;
|
|
interrupts = <10>;
|
|
|
|
clocks = <&cgu JZ4780_CLK_PDMA>;
|
|
|
|
#dma-cells = <2>;
|
|
|
|
ingenic,reserved-channels = <0x3>;
|
|
};
|
|
|
|
DMA clients must use the format described in dma.txt, giving a phandle to the
|
|
DMA controller plus the following 2 integer cells:
|
|
|
|
1. Request type: The DMA request type for transfers to/from the device on
|
|
the allocated channel, as defined in the SoC documentation.
|
|
|
|
2. Channel: If set to 0xffffffff, any available channel will be allocated for
|
|
the client. Otherwise, the exact channel specified will be used. The channel
|
|
should be reserved on the DMA controller using the ingenic,reserved-channels
|
|
property.
|
|
|
|
Example:
|
|
|
|
uart0: serial@10030000 {
|
|
...
|
|
dmas = <&dma 0x14 0xffffffff
|
|
&dma 0x15 0xffffffff>;
|
|
dma-names = "tx", "rx";
|
|
...
|
|
};
|