mirror of
https://github.com/edk2-porting/linux-next.git
synced 2024-12-28 23:23:55 +08:00
1da177e4c3
Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
53 lines
1.6 KiB
Plaintext
53 lines
1.6 KiB
Plaintext
These instructions are deliberately very basic. If you want something clever,
|
|
go read the real docs ;-) Please don't add more stuff, but feel free to
|
|
correct my mistakes ;-) (mbligh@aracnet.com)
|
|
Thanks to John Levon, Dave Hansen, et al. for help writing this.
|
|
|
|
<test> is the thing you're trying to measure.
|
|
Make sure you have the correct System.map / vmlinux referenced!
|
|
|
|
It is probably easiest to use "make install" for linux and hack
|
|
/sbin/installkernel to copy vmlinux to /boot, in addition to vmlinuz,
|
|
config, System.map, which are usually installed by default.
|
|
|
|
Readprofile
|
|
-----------
|
|
A recent readprofile command is needed for 2.6, such as found in util-linux
|
|
2.12a, which can be downloaded from:
|
|
|
|
http://www.kernel.org/pub/linux/utils/util-linux/
|
|
|
|
Most distributions will ship it already.
|
|
|
|
Add "profile=2" to the kernel command line.
|
|
|
|
clear readprofile -r
|
|
<test>
|
|
dump output readprofile -m /boot/System.map > captured_profile
|
|
|
|
Oprofile
|
|
--------
|
|
Get the source (I use 0.8) from http://oprofile.sourceforge.net/
|
|
and add "idle=poll" to the kernel command line
|
|
Configure with CONFIG_PROFILING=y and CONFIG_OPROFILE=y & reboot on new kernel
|
|
./configure --with-kernel-support
|
|
make install
|
|
|
|
For superior results, be sure to enable the local APIC. If opreport sees
|
|
a 0Hz CPU, APIC was not on. Be aware that idle=poll may mean a performance
|
|
penalty.
|
|
|
|
One time setup:
|
|
opcontrol --setup --vmlinux=/boot/vmlinux
|
|
|
|
clear opcontrol --reset
|
|
start opcontrol --start
|
|
<test>
|
|
stop opcontrol --stop
|
|
dump output opreport > output_file
|
|
|
|
To only report on the kernel, run opreport /boot/vmlinux > output_file
|
|
|
|
A reset is needed to clear old statistics, which survive a reboot.
|
|
|