2
0
mirror of https://github.com/edk2-porting/linux-next.git synced 2024-12-23 12:43:55 +08:00
linux-next/drivers/pwm/pwm-tiecap.c
Jingoo Han c10d50631f pwm: pwm-tiecap: Remove unnecessary OOM messages
The site-specific OOM messages are unnecessary, because they
duplicate the MM subsystem generic OOM message.

Signed-off-by: Jingoo Han <jg1.han@samsung.com>
Signed-off-by: Thierry Reding <thierry.reding@gmail.com>
2014-04-28 13:37:48 +02:00

347 lines
8.7 KiB
C

/*
* ECAP PWM driver
*
* Copyright (C) 2012 Texas Instruments, Inc. - http://www.ti.com/
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
* the Free Software Foundation; either version 2 of the License, or
* (at your option) any later version.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*
* You should have received a copy of the GNU General Public License
* along with this program; if not, write to the Free Software
* Foundation, Inc., 675 Mass Ave, Cambridge, MA 02139, USA.
*/
#include <linux/module.h>
#include <linux/platform_device.h>
#include <linux/io.h>
#include <linux/err.h>
#include <linux/clk.h>
#include <linux/pm_runtime.h>
#include <linux/pwm.h>
#include <linux/of_device.h>
#include "pwm-tipwmss.h"
/* ECAP registers and bits definitions */
#define CAP1 0x08
#define CAP2 0x0C
#define CAP3 0x10
#define CAP4 0x14
#define ECCTL2 0x2A
#define ECCTL2_APWM_POL_LOW BIT(10)
#define ECCTL2_APWM_MODE BIT(9)
#define ECCTL2_SYNC_SEL_DISA (BIT(7) | BIT(6))
#define ECCTL2_TSCTR_FREERUN BIT(4)
struct ecap_context {
u32 cap3;
u32 cap4;
u16 ecctl2;
};
struct ecap_pwm_chip {
struct pwm_chip chip;
unsigned int clk_rate;
void __iomem *mmio_base;
struct ecap_context ctx;
};
static inline struct ecap_pwm_chip *to_ecap_pwm_chip(struct pwm_chip *chip)
{
return container_of(chip, struct ecap_pwm_chip, chip);
}
/*
* period_ns = 10^9 * period_cycles / PWM_CLK_RATE
* duty_ns = 10^9 * duty_cycles / PWM_CLK_RATE
*/
static int ecap_pwm_config(struct pwm_chip *chip, struct pwm_device *pwm,
int duty_ns, int period_ns)
{
struct ecap_pwm_chip *pc = to_ecap_pwm_chip(chip);
unsigned long long c;
unsigned long period_cycles, duty_cycles;
unsigned int reg_val;
if (period_ns > NSEC_PER_SEC)
return -ERANGE;
c = pc->clk_rate;
c = c * period_ns;
do_div(c, NSEC_PER_SEC);
period_cycles = (unsigned long)c;
if (period_cycles < 1) {
period_cycles = 1;
duty_cycles = 1;
} else {
c = pc->clk_rate;
c = c * duty_ns;
do_div(c, NSEC_PER_SEC);
duty_cycles = (unsigned long)c;
}
pm_runtime_get_sync(pc->chip.dev);
reg_val = readw(pc->mmio_base + ECCTL2);
/* Configure APWM mode & disable sync option */
reg_val |= ECCTL2_APWM_MODE | ECCTL2_SYNC_SEL_DISA;
writew(reg_val, pc->mmio_base + ECCTL2);
if (!test_bit(PWMF_ENABLED, &pwm->flags)) {
/* Update active registers if not running */
writel(duty_cycles, pc->mmio_base + CAP2);
writel(period_cycles, pc->mmio_base + CAP1);
} else {
/*
* Update shadow registers to configure period and
* compare values. This helps current PWM period to
* complete on reconfiguring
*/
writel(duty_cycles, pc->mmio_base + CAP4);
writel(period_cycles, pc->mmio_base + CAP3);
}
if (!test_bit(PWMF_ENABLED, &pwm->flags)) {
reg_val = readw(pc->mmio_base + ECCTL2);
/* Disable APWM mode to put APWM output Low */
reg_val &= ~ECCTL2_APWM_MODE;
writew(reg_val, pc->mmio_base + ECCTL2);
}
pm_runtime_put_sync(pc->chip.dev);
return 0;
}
static int ecap_pwm_set_polarity(struct pwm_chip *chip, struct pwm_device *pwm,
enum pwm_polarity polarity)
{
struct ecap_pwm_chip *pc = to_ecap_pwm_chip(chip);
unsigned short reg_val;
pm_runtime_get_sync(pc->chip.dev);
reg_val = readw(pc->mmio_base + ECCTL2);
if (polarity == PWM_POLARITY_INVERSED)
/* Duty cycle defines LOW period of PWM */
reg_val |= ECCTL2_APWM_POL_LOW;
else
/* Duty cycle defines HIGH period of PWM */
reg_val &= ~ECCTL2_APWM_POL_LOW;
writew(reg_val, pc->mmio_base + ECCTL2);
pm_runtime_put_sync(pc->chip.dev);
return 0;
}
static int ecap_pwm_enable(struct pwm_chip *chip, struct pwm_device *pwm)
{
struct ecap_pwm_chip *pc = to_ecap_pwm_chip(chip);
unsigned int reg_val;
/* Leave clock enabled on enabling PWM */
pm_runtime_get_sync(pc->chip.dev);
/*
* Enable 'Free run Time stamp counter mode' to start counter
* and 'APWM mode' to enable APWM output
*/
reg_val = readw(pc->mmio_base + ECCTL2);
reg_val |= ECCTL2_TSCTR_FREERUN | ECCTL2_APWM_MODE;
writew(reg_val, pc->mmio_base + ECCTL2);
return 0;
}
static void ecap_pwm_disable(struct pwm_chip *chip, struct pwm_device *pwm)
{
struct ecap_pwm_chip *pc = to_ecap_pwm_chip(chip);
unsigned int reg_val;
/*
* Disable 'Free run Time stamp counter mode' to stop counter
* and 'APWM mode' to put APWM output to low
*/
reg_val = readw(pc->mmio_base + ECCTL2);
reg_val &= ~(ECCTL2_TSCTR_FREERUN | ECCTL2_APWM_MODE);
writew(reg_val, pc->mmio_base + ECCTL2);
/* Disable clock on PWM disable */
pm_runtime_put_sync(pc->chip.dev);
}
static void ecap_pwm_free(struct pwm_chip *chip, struct pwm_device *pwm)
{
if (test_bit(PWMF_ENABLED, &pwm->flags)) {
dev_warn(chip->dev, "Removing PWM device without disabling\n");
pm_runtime_put_sync(chip->dev);
}
}
static const struct pwm_ops ecap_pwm_ops = {
.free = ecap_pwm_free,
.config = ecap_pwm_config,
.set_polarity = ecap_pwm_set_polarity,
.enable = ecap_pwm_enable,
.disable = ecap_pwm_disable,
.owner = THIS_MODULE,
};
static const struct of_device_id ecap_of_match[] = {
{ .compatible = "ti,am33xx-ecap" },
{},
};
MODULE_DEVICE_TABLE(of, ecap_of_match);
static int ecap_pwm_probe(struct platform_device *pdev)
{
int ret;
struct resource *r;
struct clk *clk;
struct ecap_pwm_chip *pc;
u16 status;
pc = devm_kzalloc(&pdev->dev, sizeof(*pc), GFP_KERNEL);
if (!pc)
return -ENOMEM;
clk = devm_clk_get(&pdev->dev, "fck");
if (IS_ERR(clk)) {
dev_err(&pdev->dev, "failed to get clock\n");
return PTR_ERR(clk);
}
pc->clk_rate = clk_get_rate(clk);
if (!pc->clk_rate) {
dev_err(&pdev->dev, "failed to get clock rate\n");
return -EINVAL;
}
pc->chip.dev = &pdev->dev;
pc->chip.ops = &ecap_pwm_ops;
pc->chip.of_xlate = of_pwm_xlate_with_flags;
pc->chip.of_pwm_n_cells = 3;
pc->chip.base = -1;
pc->chip.npwm = 1;
r = platform_get_resource(pdev, IORESOURCE_MEM, 0);
pc->mmio_base = devm_ioremap_resource(&pdev->dev, r);
if (IS_ERR(pc->mmio_base))
return PTR_ERR(pc->mmio_base);
ret = pwmchip_add(&pc->chip);
if (ret < 0) {
dev_err(&pdev->dev, "pwmchip_add() failed: %d\n", ret);
return ret;
}
pm_runtime_enable(&pdev->dev);
pm_runtime_get_sync(&pdev->dev);
status = pwmss_submodule_state_change(pdev->dev.parent,
PWMSS_ECAPCLK_EN);
if (!(status & PWMSS_ECAPCLK_EN_ACK)) {
dev_err(&pdev->dev, "PWMSS config space clock enable failed\n");
ret = -EINVAL;
goto pwmss_clk_failure;
}
pm_runtime_put_sync(&pdev->dev);
platform_set_drvdata(pdev, pc);
return 0;
pwmss_clk_failure:
pm_runtime_put_sync(&pdev->dev);
pm_runtime_disable(&pdev->dev);
pwmchip_remove(&pc->chip);
return ret;
}
static int ecap_pwm_remove(struct platform_device *pdev)
{
struct ecap_pwm_chip *pc = platform_get_drvdata(pdev);
pm_runtime_get_sync(&pdev->dev);
/*
* Due to hardware misbehaviour, acknowledge of the stop_req
* is missing. Hence checking of the status bit skipped.
*/
pwmss_submodule_state_change(pdev->dev.parent, PWMSS_ECAPCLK_STOP_REQ);
pm_runtime_put_sync(&pdev->dev);
pm_runtime_disable(&pdev->dev);
return pwmchip_remove(&pc->chip);
}
#ifdef CONFIG_PM_SLEEP
static void ecap_pwm_save_context(struct ecap_pwm_chip *pc)
{
pm_runtime_get_sync(pc->chip.dev);
pc->ctx.ecctl2 = readw(pc->mmio_base + ECCTL2);
pc->ctx.cap4 = readl(pc->mmio_base + CAP4);
pc->ctx.cap3 = readl(pc->mmio_base + CAP3);
pm_runtime_put_sync(pc->chip.dev);
}
static void ecap_pwm_restore_context(struct ecap_pwm_chip *pc)
{
writel(pc->ctx.cap3, pc->mmio_base + CAP3);
writel(pc->ctx.cap4, pc->mmio_base + CAP4);
writew(pc->ctx.ecctl2, pc->mmio_base + ECCTL2);
}
static int ecap_pwm_suspend(struct device *dev)
{
struct ecap_pwm_chip *pc = dev_get_drvdata(dev);
struct pwm_device *pwm = pc->chip.pwms;
ecap_pwm_save_context(pc);
/* Disable explicitly if PWM is running */
if (test_bit(PWMF_ENABLED, &pwm->flags))
pm_runtime_put_sync(dev);
return 0;
}
static int ecap_pwm_resume(struct device *dev)
{
struct ecap_pwm_chip *pc = dev_get_drvdata(dev);
struct pwm_device *pwm = pc->chip.pwms;
/* Enable explicitly if PWM was running */
if (test_bit(PWMF_ENABLED, &pwm->flags))
pm_runtime_get_sync(dev);
ecap_pwm_restore_context(pc);
return 0;
}
#endif
static SIMPLE_DEV_PM_OPS(ecap_pwm_pm_ops, ecap_pwm_suspend, ecap_pwm_resume);
static struct platform_driver ecap_pwm_driver = {
.driver = {
.name = "ecap",
.owner = THIS_MODULE,
.of_match_table = ecap_of_match,
.pm = &ecap_pwm_pm_ops,
},
.probe = ecap_pwm_probe,
.remove = ecap_pwm_remove,
};
module_platform_driver(ecap_pwm_driver);
MODULE_DESCRIPTION("ECAP PWM driver");
MODULE_AUTHOR("Texas Instruments");
MODULE_LICENSE("GPL");