mirror of
https://github.com/edk2-porting/linux-next.git
synced 2024-12-24 05:04:00 +08:00
529ba0d966
Bugfix to spi_bitbang infrastructure: make sure to always set transfer parameters on the first pass through the message's per-transfer loop. This can matter with drivers that replace the per-word or per-buffer transfer primitives, on busses with multiple SPI devices. Previously, this could have started messages using the settings left after previous messages. The problem was observed when a high speed chip (m25p80 type flash) was running very slowly because a low speed device (avr8 microcontroller) had previously used the bus. Similar faults could have driven the low speed device too fast, or used an unexpected word size. Acked-by: Steven A. Falco <sfalco@harris.com> Signed-off-by: David Brownell <dbrownell@users.sourceforge.net> Signed-off-by: Andrew Morton <akpm@linux-foundation.org> Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org> |
||
|---|---|---|
| .. | ||
| amba-pl022.c | ||
| atmel_spi.c | ||
| atmel_spi.h | ||
| au1550_spi.c | ||
| Kconfig | ||
| Makefile | ||
| mpc52xx_psc_spi.c | ||
| omap2_mcspi.c | ||
| omap_uwire.c | ||
| orion_spi.c | ||
| pxa2xx_spi.c | ||
| spi_bfin5xx.c | ||
| spi_bitbang.c | ||
| spi_butterfly.c | ||
| spi_gpio.c | ||
| spi_imx.c | ||
| spi_lm70llp.c | ||
| spi_mpc8xxx.c | ||
| spi_s3c24xx_gpio.c | ||
| spi_s3c24xx.c | ||
| spi_sh_sci.c | ||
| spi_txx9.c | ||
| spi.c | ||
| spidev.c | ||
| tle62x0.c | ||
| xilinx_spi.c | ||