Lee Jones db43e6c473 ab8500-bm: Add usb power path support ... AB8540 supports power path function in USB charging mode for fast power up with dead and weak battery, and it could extend the battery age. When USB charging starts, if the Vbattrue is below than SW cut off voltage, power path and pre-charge should be enabled. If Vbattrue is higher than SW cut off voltage, power path and pre-charge should be disabled. This is to make sure full current to battery charge. At the end of charge, power path should be enable again to reduce charging the battery again. Signed-off-by: Lee Jones <lee.jones@linaro.org>		2013-03-07 12:35:46 +08:00
..
ab8500-bm.h	ab8500-bm: Add usb power path support	2013-03-07 12:35:46 +08:00
ab8500-codec.h	ASoC: codecs: Enable AB8500 CODEC for Device Tree	2012-09-20 09:10:57 +02:00
ab8500-gpadc.h	mfd: ab8500-debug: Add support for the AB8540	2013-03-07 12:28:28 +08:00
ab8500-gpio.h	ARM: ux500: remove irq_base property from platform_data	2013-02-10 15:49:43 +01:00
ab8500-sysctrl.h	mfd: ab8500-sysctrl: Add new reset function	2013-03-07 12:28:16 +08:00
ab8500.h	mfd: ab8500-core: Add Interrupt support for ab8540	2013-03-07 12:27:47 +08:00
ux500_chargalg.h	ab8500-bm: Add usb power path support	2013-03-07 12:35:46 +08:00