mirror of
https://github.com/edk2-porting/linux-next.git
synced 2024-12-29 15:43:59 +08:00
9bb86777fb
This patch adds sysfs "role" for usb role swap. This parameter can be read and write. If you use this file as the following, you can swap the usb role. For example: 1) Connect a usb cable using 2 Salvator-x boards 2) On A-Device (ID pin is low), you input the following command: # echo peripheral > /sys/devices/platform/soc/ee080200.usb-phy/role 3) On B-Device (ID pin is high), you input the following command: # echo host > /sys/devices/platform/soc/ee080200.usb-phy/role Then, the A-device acts as a peripheral and the B-device acts as a host. Please note that A-Device must input the following command if you want the board to act as a host again. (even if you disconnect the usb cable, since id state may be the same, the A-Device keeps to act as peripheral.) # echo host > /sys/devices/platform/soc/ee080200.usb-phy/role Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com> Reviewed-by: Peter Chen <peter.chen@nxp.com> Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>
16 lines
553 B
Plaintext
16 lines
553 B
Plaintext
What: /sys/devices/platform/<phy-name>/role
|
|
Date: October 2016
|
|
KernelVersion: 4.10
|
|
Contact: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
|
|
Description:
|
|
This file can be read and write.
|
|
The file can show/change the phy mode for role swap of usb.
|
|
|
|
Write the following strings to change the mode:
|
|
"host" - switching mode from peripheral to host.
|
|
"peripheral" - switching mode from host to peripheral.
|
|
|
|
Read the file, then it shows the following strings:
|
|
"host" - The mode is host now.
|
|
"peripheral" - The mode is peripheral now.
|