mirror of
https://github.com/edk2-porting/linux-next.git
synced 2024-12-23 04:34:11 +08:00
96895199c8
Pull i2c updates from Wolfram Sang:
"For 3.19, the I2C subsystem has to offer special candy this time.
Right in time for Christmas :)
- I2C slave framework: finally, a generic mechanism for Linux being
an I2C slave (if the bus driver supports that). Docs are still
missing but will come later this cycle, the code is good enough to
go.
- I2C muxes represent their topology in sysfs much more detailed.
This will help users to navigate around much easier.
- irq population of i2c clients is now done at probe time, not device
creation time, to have better support for deferred probing.
- new drivers for Imagination SCB, Amlogic Meson
- DMA support added for Freescale IMX, Renesas SHMobile
- slightly bigger driver updates to OMAP, i801, AT91, and rk3x
(mostly quirk handling, timing updates, and using better kernel
interfaces)
- eeprom driver can now write with byte-access (very slow, but OK to
have)
- and the bunch of smaller fixes, cleanups, ID updates..."
* 'i2c/for-3.19' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux: (56 commits)
i2c: sh_mobile: remove unneeded DMA mask
i2c: rcar: add slave support
i2c: slave-eeprom: add eeprom simulator driver
i2c: core changes for slave support
MAINTAINERS: add I2C dt bindings also to I2C realm
i2c: designware: Fix falling time bindings doc
i2c: davinci: switch to use platform_get_irq
Documentation: i2c: Use PM ops instead of legacy suspend/resume
i2c: sh_mobile: optimize irq entry
i2c: pxa: add support for SCCB devices
omap: i2c: don't check bus state IP rev3.3 and earlier
i2c: s3c2410: Handle i2c sys_cfg register in i2c driver
i2c: rk3x: add Kconfig dependency on COMMON_CLK
i2c: omap: add notes related to i2c multimaster mode
i2c: omap: don't reset controller if Arbitration Lost detected
i2c: omap: implement workaround for handling invalid BB-bit values
i2c: omap: cleanup register definitions
i2c: rk3x: handle dynamic clock rate changes correctly
i2c: at91: enable probe deferring on dma channel request
i2c: at91: remove legacy DMA support
...
110 lines
4.1 KiB
Makefile
110 lines
4.1 KiB
Makefile
#
|
|
# Makefile for the i2c bus drivers.
|
|
#
|
|
|
|
# ACPI drivers
|
|
obj-$(CONFIG_I2C_SCMI) += i2c-scmi.o
|
|
|
|
# PC SMBus host controller drivers
|
|
obj-$(CONFIG_I2C_ALI1535) += i2c-ali1535.o
|
|
obj-$(CONFIG_I2C_ALI1563) += i2c-ali1563.o
|
|
obj-$(CONFIG_I2C_ALI15X3) += i2c-ali15x3.o
|
|
obj-$(CONFIG_I2C_AMD756) += i2c-amd756.o
|
|
obj-$(CONFIG_I2C_AMD756_S4882) += i2c-amd756-s4882.o
|
|
obj-$(CONFIG_I2C_AMD8111) += i2c-amd8111.o
|
|
obj-$(CONFIG_I2C_I801) += i2c-i801.o
|
|
obj-$(CONFIG_I2C_ISCH) += i2c-isch.o
|
|
obj-$(CONFIG_I2C_ISMT) += i2c-ismt.o
|
|
obj-$(CONFIG_I2C_NFORCE2) += i2c-nforce2.o
|
|
obj-$(CONFIG_I2C_NFORCE2_S4985) += i2c-nforce2-s4985.o
|
|
obj-$(CONFIG_I2C_PIIX4) += i2c-piix4.o
|
|
obj-$(CONFIG_I2C_SIS5595) += i2c-sis5595.o
|
|
obj-$(CONFIG_I2C_SIS630) += i2c-sis630.o
|
|
obj-$(CONFIG_I2C_SIS96X) += i2c-sis96x.o
|
|
obj-$(CONFIG_I2C_VIA) += i2c-via.o
|
|
obj-$(CONFIG_I2C_VIAPRO) += i2c-viapro.o
|
|
|
|
# Mac SMBus host controller drivers
|
|
obj-$(CONFIG_I2C_HYDRA) += i2c-hydra.o
|
|
obj-$(CONFIG_I2C_POWERMAC) += i2c-powermac.o
|
|
|
|
# Embedded system I2C/SMBus host controller drivers
|
|
obj-$(CONFIG_I2C_AT91) += i2c-at91.o
|
|
obj-$(CONFIG_I2C_AU1550) += i2c-au1550.o
|
|
obj-$(CONFIG_I2C_AXXIA) += i2c-axxia.o
|
|
obj-$(CONFIG_I2C_BCM2835) += i2c-bcm2835.o
|
|
obj-$(CONFIG_I2C_BLACKFIN_TWI) += i2c-bfin-twi.o
|
|
obj-$(CONFIG_I2C_CADENCE) += i2c-cadence.o
|
|
obj-$(CONFIG_I2C_CBUS_GPIO) += i2c-cbus-gpio.o
|
|
obj-$(CONFIG_I2C_CPM) += i2c-cpm.o
|
|
obj-$(CONFIG_I2C_DAVINCI) += i2c-davinci.o
|
|
obj-$(CONFIG_I2C_DESIGNWARE_CORE) += i2c-designware-core.o
|
|
obj-$(CONFIG_I2C_DESIGNWARE_PLATFORM) += i2c-designware-platform.o
|
|
i2c-designware-platform-objs := i2c-designware-platdrv.o
|
|
obj-$(CONFIG_I2C_DESIGNWARE_PCI) += i2c-designware-pci.o
|
|
i2c-designware-pci-objs := i2c-designware-pcidrv.o
|
|
obj-$(CONFIG_I2C_EFM32) += i2c-efm32.o
|
|
obj-$(CONFIG_I2C_EG20T) += i2c-eg20t.o
|
|
obj-$(CONFIG_I2C_EXYNOS5) += i2c-exynos5.o
|
|
obj-$(CONFIG_I2C_GPIO) += i2c-gpio.o
|
|
obj-$(CONFIG_I2C_HIGHLANDER) += i2c-highlander.o
|
|
obj-$(CONFIG_I2C_HIX5HD2) += i2c-hix5hd2.o
|
|
obj-$(CONFIG_I2C_IBM_IIC) += i2c-ibm_iic.o
|
|
obj-$(CONFIG_I2C_IMG) += i2c-img-scb.o
|
|
obj-$(CONFIG_I2C_IMX) += i2c-imx.o
|
|
obj-$(CONFIG_I2C_IOP3XX) += i2c-iop3xx.o
|
|
obj-$(CONFIG_I2C_KEMPLD) += i2c-kempld.o
|
|
obj-$(CONFIG_I2C_MESON) += i2c-meson.o
|
|
obj-$(CONFIG_I2C_MPC) += i2c-mpc.o
|
|
obj-$(CONFIG_I2C_MV64XXX) += i2c-mv64xxx.o
|
|
obj-$(CONFIG_I2C_MXS) += i2c-mxs.o
|
|
obj-$(CONFIG_I2C_NOMADIK) += i2c-nomadik.o
|
|
obj-$(CONFIG_I2C_OCORES) += i2c-ocores.o
|
|
obj-$(CONFIG_I2C_OMAP) += i2c-omap.o
|
|
obj-$(CONFIG_I2C_PASEMI) += i2c-pasemi.o
|
|
obj-$(CONFIG_I2C_PCA_PLATFORM) += i2c-pca-platform.o
|
|
obj-$(CONFIG_I2C_PMCMSP) += i2c-pmcmsp.o
|
|
obj-$(CONFIG_I2C_PNX) += i2c-pnx.o
|
|
obj-$(CONFIG_I2C_PUV3) += i2c-puv3.o
|
|
obj-$(CONFIG_I2C_PXA) += i2c-pxa.o
|
|
obj-$(CONFIG_I2C_PXA_PCI) += i2c-pxa-pci.o
|
|
obj-$(CONFIG_I2C_QUP) += i2c-qup.o
|
|
obj-$(CONFIG_I2C_RIIC) += i2c-riic.o
|
|
obj-$(CONFIG_I2C_RK3X) += i2c-rk3x.o
|
|
obj-$(CONFIG_I2C_S3C2410) += i2c-s3c2410.o
|
|
obj-$(CONFIG_I2C_SH7760) += i2c-sh7760.o
|
|
obj-$(CONFIG_I2C_SH_MOBILE) += i2c-sh_mobile.o
|
|
obj-$(CONFIG_I2C_SIMTEC) += i2c-simtec.o
|
|
obj-$(CONFIG_I2C_SIRF) += i2c-sirf.o
|
|
obj-$(CONFIG_I2C_ST) += i2c-st.o
|
|
obj-$(CONFIG_I2C_STU300) += i2c-stu300.o
|
|
obj-$(CONFIG_I2C_SUN6I_P2WI) += i2c-sun6i-p2wi.o
|
|
obj-$(CONFIG_I2C_TEGRA) += i2c-tegra.o
|
|
obj-$(CONFIG_I2C_VERSATILE) += i2c-versatile.o
|
|
obj-$(CONFIG_I2C_WMT) += i2c-wmt.o
|
|
obj-$(CONFIG_I2C_OCTEON) += i2c-octeon.o
|
|
obj-$(CONFIG_I2C_XILINX) += i2c-xiic.o
|
|
obj-$(CONFIG_I2C_XLR) += i2c-xlr.o
|
|
obj-$(CONFIG_I2C_RCAR) += i2c-rcar.o
|
|
|
|
# External I2C/SMBus adapter drivers
|
|
obj-$(CONFIG_I2C_DIOLAN_U2C) += i2c-diolan-u2c.o
|
|
obj-$(CONFIG_I2C_DLN2) += i2c-dln2.o
|
|
obj-$(CONFIG_I2C_PARPORT) += i2c-parport.o
|
|
obj-$(CONFIG_I2C_PARPORT_LIGHT) += i2c-parport-light.o
|
|
obj-$(CONFIG_I2C_ROBOTFUZZ_OSIF) += i2c-robotfuzz-osif.o
|
|
obj-$(CONFIG_I2C_TAOS_EVM) += i2c-taos-evm.o
|
|
obj-$(CONFIG_I2C_TINY_USB) += i2c-tiny-usb.o
|
|
obj-$(CONFIG_I2C_VIPERBOARD) += i2c-viperboard.o
|
|
|
|
# Other I2C/SMBus bus drivers
|
|
obj-$(CONFIG_I2C_ACORN) += i2c-acorn.o
|
|
obj-$(CONFIG_I2C_BCM_KONA) += i2c-bcm-kona.o
|
|
obj-$(CONFIG_I2C_CROS_EC_TUNNEL) += i2c-cros-ec-tunnel.o
|
|
obj-$(CONFIG_I2C_ELEKTOR) += i2c-elektor.o
|
|
obj-$(CONFIG_I2C_PCA_ISA) += i2c-pca-isa.o
|
|
obj-$(CONFIG_I2C_SIBYTE) += i2c-sibyte.o
|
|
obj-$(CONFIG_SCx200_ACB) += scx200_acb.o
|
|
|
|
ccflags-$(CONFIG_I2C_DEBUG_BUS) := -DDEBUG
|