2
0
mirror of https://github.com/edk2-porting/linux-next.git synced 2024-12-23 20:53:53 +08:00
linux-next/drivers/mtd/nand
Sascha Hauer 8283079696 mtd: nand: mxc: Add timing setup for v2 controllers
So far we relied on reset default or the bootloader to configure a
suitable clk rate for the Nand controller. This works but we can
optimize the timing for better performance. This sets the clk rate for
v2 controllers (i.MX25/35) based on the timing mode read from the ONFI
parameter page. This may also enable the symmetric mode (aks EDO mode)
if necessary which reads one word per clock cycle.
Tested on an i.MX25 with a Micron MT29F4G08ABBDAHC attached.

Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Signed-off-by: Boris Brezillon <boris.brezillon@free-electrons.com>
2016-09-23 09:35:16 +02:00
..
bcm47xxnflash mtd: nand: make use of nand_set/get_controller_data() helpers 2016-01-07 10:23:41 -08:00
brcmnand mtd: brcmnand: iProc big endian and ONFI support 2016-09-23 09:35:16 +02:00
gpmi-nand mtd: nand: gpmi: get correct free oob space 2016-09-23 09:35:16 +02:00
ams-delta.c mtd: nand: ams-delta: set ECC algorithm explicitly 2016-04-19 22:05:31 +02:00
atmel_nand_ecc.h mtd: atmel_nand: Support 32-bit ECC strength 2016-02-12 10:27:48 -08:00
atmel_nand_nfc.h Revert "mtd: atmel_nand: Support variable RB_EDGE interrupts" 2016-05-25 20:06:28 -07:00
atmel_nand.c Revert "mtd: atmel_nand: Support variable RB_EDGE interrupts" 2016-05-25 20:06:28 -07:00
au1550nd.c mtd: nand: au1550nd: set ECC algorithm explicitly 2016-05-05 23:51:53 +02:00
bf5xx_nand.c mtd: nand: import nand_hw_control_init() 2016-09-23 09:35:16 +02:00
cafe_nand.c mtd: nand: cafe: switch to mtd_ooblayout_ops 2016-05-05 23:51:39 +02:00
cmx270_nand.c mtd: nand: cmx270: set ECC algorithm explicitly 2016-05-05 23:51:54 +02:00
cs553x_nand.c mtd: nand: remove useless mtd->priv = chip assignments 2015-12-18 13:21:40 -08:00
davinci_nand.c mtd: nand: davinci: set ECC algorithm explicitly 2016-05-05 23:52:02 +02:00
denali_dt.c mtd: nand: drop owner assignment from platform_drivers 2014-10-20 16:20:58 +02:00
denali_pci.c mtd: denali_pci: switch to dev_err() 2015-08-18 17:21:37 -07:00
denali.c mtd: nand: denali: switch to mtd_ooblayout_ops 2016-05-05 23:51:40 +02:00
denali.h mtd: nand: denali: use the mtd instance embedded in struct nand_chip 2015-12-18 13:13:50 -08:00
diskonchip.c mtd: nand: diskonchip: switch to mtd_ooblayout_ops 2016-05-05 23:51:40 +02:00
docg4.c mtd: nand: import nand_hw_control_init() 2016-09-23 09:35:16 +02:00
fsl_elbc_nand.c mtd: nand: import nand_hw_control_init() 2016-09-23 09:35:16 +02:00
fsl_ifc_nand.c mtd: nand: import nand_hw_control_init() 2016-09-23 09:35:16 +02:00
fsl_upm.c mtd: nand: fsl_upm: set ECC algorithm explicitly 2016-05-05 23:51:54 +02:00
fsmc_nand.c mtd: mtd: drop NAND_ECC_SOFT_BCH enum value 2016-05-05 23:55:13 +02:00
gpio.c mtd: nand: gpio: set ECC algorithm explicitly 2016-04-19 22:05:31 +02:00
hisi504_nand.c mtd: nand: hisi504: rely on generic DT parsing done in nand_scan_ident() 2016-05-05 23:51:58 +02:00
jz4740_nand.c mtd: nand: jz4740: Remove unused local variable 2016-05-05 23:51:56 +02:00
jz4780_bch.c mtd: nand: jz4780: Update MODULE_AUTHOR email address 2016-07-11 08:40:19 +02:00
jz4780_bch.h mtd: nand: jz4780: driver for NAND devices on JZ4780 SoCs 2016-01-07 09:35:11 -08:00
jz4780_nand.c mtd: nand: import nand_hw_control_init() 2016-09-23 09:35:16 +02:00
Kconfig mtd: nand: Allow MTD_NAND_OMAP2 to be usable on Keystone devices 2016-09-23 09:35:16 +02:00
lpc32xx_mlc.c mtd: nand: lpc32xx: switch to mtd_ooblayout_ops 2016-05-05 23:51:45 +02:00
lpc32xx_slc.c mtd: nand: lpc32xx: rely on generic DT parsing done in nand_scan_ident() 2016-05-05 23:51:58 +02:00
Makefile mtd: mediatek: driver for MTK Smart Device 2016-07-11 08:39:54 +02:00
mpc5121_nfc.c mtd: nand: mpc5121_nfc: set ECC algorithm explicitly 2016-05-05 23:51:53 +02:00
mtk_ecc.c mtd: mediatek: driver for MTK Smart Device 2016-07-11 08:39:54 +02:00
mtk_ecc.h mtd: mediatek: driver for MTK Smart Device 2016-07-11 08:39:54 +02:00
mtk_nand.c mtd: mediatek: driver for MTK Smart Device 2016-07-11 08:39:54 +02:00
mxc_nand.c mtd: nand: mxc: Add timing setup for v2 controllers 2016-09-23 09:35:16 +02:00
nand_base.c mtd: nand: automate NAND timings selection 2016-09-23 09:35:16 +02:00
nand_bbt.c mtd: nand_bbt: scan for next free bbt block if writing bbt fails 2016-09-23 09:35:16 +02:00
nand_bch.c mtd: nand_bch: fix spelling of "probably" 2016-05-06 09:45:45 -07:00
nand_ecc.c mtd: nand: return consistent error codes in ecc.correct() implementations 2016-01-06 18:45:46 -08:00
nand_ids.c mtd: nand: add ESMT manufacturer 2016-06-09 21:23:20 +02:00
nand_timings.c mtd: nand: Expose data interface for ONFI mode 0 2016-09-23 09:35:16 +02:00
nandsim.c MTD updates for v4.7: 2016-05-24 11:00:20 -07:00
ndfc.c mtd: nand: import nand_hw_control_init() 2016-09-23 09:35:16 +02:00
nuc900_nand.c mtd: nand: nuc900: set ECC algorithm explicitly 2016-04-19 22:05:32 +02:00
omap2.c MTD updates for v4.8: 2016-08-02 17:05:11 -04:00
omap_elm.c mtd: omap_elm: print interrupt resource using %pr 2015-12-18 10:16:17 -08:00
orion_nand.c mtd: nand: orion: set ECC algorithm explicitly 2016-04-19 22:05:33 +02:00
pasemi_nand.c mtd: nand: pasemi: switch to dev_* printing functions 2016-04-19 22:05:35 +02:00
plat_nand.c mtd: nand: plat: set ECC algorithm explicitly 2016-04-19 22:05:34 +02:00
pxa3xx_nand.c mtd: nand: import nand_hw_control_init() 2016-09-23 09:35:16 +02:00
qcom_nandc.c mtd: nand: import nand_hw_control_init() 2016-09-23 09:35:16 +02:00
r852.c mtd: nand: make use of nand_set/get_controller_data() helpers 2016-01-07 10:23:41 -08:00
r852.h mtd: nand: r852: use the mtd instance embedded in struct nand_chip 2015-12-18 10:54:41 -08:00
s3c2410.c mtd: nand: s3c2410: Register cpufreq notifier only on S3C24xx 2016-09-23 09:35:16 +02:00
sh_flctl.c mtd: nand: sh_flctl: handle dma_submit() errors 2016-09-23 09:35:16 +02:00
sharpsl.c mtd: nand: sharpsl: switch to mtd_ooblayout_ops 2016-05-05 23:51:36 +02:00
sm_common.c mtd: nand: sm_common: switch to mtd_ooblayout_ops 2016-05-05 23:51:48 +02:00
sm_common.h mtd: use __packed shorthand 2014-08-19 11:53:08 -07:00
socrates_nand.c mtd: nand: socrates: set ECC algorithm explicitly 2016-04-19 22:05:35 +02:00
sunxi_nand.c mtd: nand: sunxi: switch from manual to automated timing config 2016-09-23 09:35:16 +02:00
tmio_nand.c mtd: nand: remove useless mtd->priv = chip assignments 2015-12-18 13:21:40 -08:00
txx9ndfmc.c mtd: nand: import nand_hw_control_init() 2016-09-23 09:35:16 +02:00
vf610_nfc.c mtd: nand: vf610: switch to mtd_ooblayout_ops 2016-05-05 23:51:48 +02:00
xway_nand.c mtd: nand: xway: add nandaddr to own struct 2016-07-11 08:40:17 +02:00