mirror of
https://github.com/edk2-porting/linux-next.git
synced 2024-12-19 02:34:01 +08:00
6ffcc18d9c
If controller driver has specified the irq_flags, mhi uses this specified irq_flags. Otherwise, mhi uses default irq_flags. The purpose of this change is to support one MSI vector for QCA6390. MHI will use one same MSI vector too in this scenario. In case of one MSI vector, IRQ_NO_BALANCING is needed when irq handler is requested. The reason is if irq migration happens, the msi_data may change too. However, the msi_data is already programmed to QCA6390 hardware during initialization phase. This msi_data inconsistence will result in crash in kernel. Another issue is in case of one MSI vector, IRQF_NO_SUSPEND will trigger WARNINGS because QCA6390 wants to disable the IRQ during the suspend. To avoid above two issues, QCA6390 driver specifies the irq_flags in case of one MSI vector when mhi_register_controller is called. Signed-off-by: Carl Huang <cjhuang@codeaurora.org> Reviewed-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org> Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org> |
||
|---|---|---|
| .. | ||
| fsl-mc | ||
| mhi | ||
| arm-cci.c | ||
| arm-integrator-lm.c | ||
| brcmstb_gisb.c | ||
| bt1-apb.c | ||
| bt1-axi.c | ||
| da8xx-mstpri.c | ||
| hisi_lpc.c | ||
| imx-weim.c | ||
| Kconfig | ||
| Makefile | ||
| mips_cdmm.c | ||
| moxtet.c | ||
| mvebu-mbus.c | ||
| omap_l3_noc.c | ||
| omap_l3_noc.h | ||
| omap_l3_smx.c | ||
| omap_l3_smx.h | ||
| omap-ocp2scp.c | ||
| qcom-ebi2.c | ||
| simple-pm-bus.c | ||
| sun50i-de2.c | ||
| sunxi-rsb.c | ||
| tegra-aconnect.c | ||
| tegra-gmi.c | ||
| ti-pwmss.c | ||
| ti-sysc.c | ||
| ts-nbus.c | ||
| uniphier-system-bus.c | ||
| vexpress-config.c | ||