2
0
mirror of https://github.com/edk2-porting/linux-next.git synced 2024-12-25 13:43:55 +08:00
linux-next/drivers/usb/image/Kconfig
Linus Torvalds 1da177e4c3 Linux-2.6.12-rc2
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.

Let it rip!
2005-04-16 15:20:36 -07:00

31 lines
1.1 KiB
Plaintext

#
# USB Imageing devices configuration
#
comment "USB Imaging devices"
depends on USB
config USB_MDC800
tristate "USB Mustek MDC800 Digital Camera support (EXPERIMENTAL)"
depends on USB && EXPERIMENTAL
---help---
Say Y here if you want to connect this type of still camera to
your computer's USB port. This driver can be used with gphoto 0.4.3
and higher (look at <http://www.gphoto.org/>).
To use it create a device node with "mknod /dev/mustek c 180 32" and
configure it in your software.
To compile this driver as a module, choose M here: the
module will be called mdc800.
config USB_MICROTEK
tristate "Microtek X6USB scanner support"
depends on USB && SCSI
help
Say Y here if you want support for the Microtek X6USB and
possibly the Phantom 336CX, Phantom C6 and ScanMaker V6U(S)L.
Support for anything but the X6 is experimental.
Please report failures and successes.
The scanner will appear as a scsi generic device to the rest
of the system. Scsi support is required.
This driver can be compiled as a module, called microtek.