2
0
mirror of https://github.com/edk2-porting/linux-next.git synced 2024-12-23 04:34:11 +08:00
linux-next/Documentation/devicetree/bindings/i2c/i2c-mpc.txt
Wolfram Sang 16c4c52435 bindings: i2c: use consistent naming for i2c binding descriptions
Filenames of devictree binding documentation seems to be arbitrary and
for me it is unneeded hazzle to find the corresponding documentation for
a specific driver.

Naming the description the same as the driver is a lot easier and makes
sense to me since the driver defines the binding it understands.

Also, remove a reference in one source to the binding documentation, since path
information easily gets stale.

Signed-off-by: Wolfram Sang <wolfram@the-dreams.de>
Cc: Rob Herring <robherring2@gmail.com>
Cc: Grant Likely <grant.likely@secretlab.ca>
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
2012-11-15 15:57:07 +00:00

65 lines
1.8 KiB
Plaintext

* I2C
Required properties :
- reg : Offset and length of the register set for the device
- compatible : should be "fsl,CHIP-i2c" where CHIP is the name of a
compatible processor, e.g. mpc8313, mpc8543, mpc8544, mpc5121,
mpc5200 or mpc5200b. For the mpc5121, an additional node
"fsl,mpc5121-i2c-ctrl" is required as shown in the example below.
Recommended properties :
- interrupts : <a b> where a is the interrupt number and b is a
field that represents an encoding of the sense and level
information for the interrupt. This should be encoded based on
the information in section 2) depending on the type of interrupt
controller you have.
- interrupt-parent : the phandle for the interrupt controller that
services interrupts for this device.
- fsl,preserve-clocking : boolean; if defined, the clock settings
from the bootloader are preserved (not touched).
- clock-frequency : desired I2C bus clock frequency in Hz.
- fsl,timeout : I2C bus timeout in microseconds.
Examples :
/* MPC5121 based board */
i2c@1740 {
#address-cells = <1>;
#size-cells = <0>;
compatible = "fsl,mpc5121-i2c", "fsl-i2c";
reg = <0x1740 0x20>;
interrupts = <11 0x8>;
interrupt-parent = <&ipic>;
clock-frequency = <100000>;
};
i2ccontrol@1760 {
compatible = "fsl,mpc5121-i2c-ctrl";
reg = <0x1760 0x8>;
};
/* MPC5200B based board */
i2c@3d00 {
#address-cells = <1>;
#size-cells = <0>;
compatible = "fsl,mpc5200b-i2c","fsl,mpc5200-i2c","fsl-i2c";
reg = <0x3d00 0x40>;
interrupts = <2 15 0>;
interrupt-parent = <&mpc5200_pic>;
fsl,preserve-clocking;
};
/* MPC8544 base board */
i2c@3100 {
#address-cells = <1>;
#size-cells = <0>;
compatible = "fsl,mpc8544-i2c", "fsl-i2c";
reg = <0x3100 0x100>;
interrupts = <43 2>;
interrupt-parent = <&mpic>;
clock-frequency = <400000>;
fsl,timeout = <10000>;
};