2
0
mirror of https://github.com/edk2-porting/linux-next.git synced 2024-12-23 20:53:53 +08:00
linux-next/Documentation/powerpc/dts-bindings/mmc-spi-slot.txt
Anton Vorontsov 3f1c6ebf57 powerpc: add mmc-spi-slot bindings
The bindings describes a case where MMC/SD/SDIO slot directly connected to
a SPI bus.  Such setups are widely used on embedded PowerPC boards.

The patch also adds the mmc-spi-slot entry to the OpenFirmware modalias
table.

Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com>
Cc: David Brownell <david-b@pacbell.net>
Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Cc: Kumar Gala <galak@gate.crashing.org>
Cc: Grant Likely <grant.likely@secretlab.ca>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
2009-04-01 08:59:23 -07:00

24 lines
725 B
Plaintext

MMC/SD/SDIO slot directly connected to a SPI bus
Required properties:
- compatible : should be "mmc-spi-slot".
- reg : should specify SPI address (chip-select number).
- spi-max-frequency : maximum frequency for this device (Hz).
- voltage-ranges : two cells are required, first cell specifies minimum
slot voltage (mV), second cell specifies maximum slot voltage (mV).
Several ranges could be specified.
- gpios : (optional) may specify GPIOs in this order: Card-Detect GPIO,
Write-Protect GPIO.
Example:
mmc-slot@0 {
compatible = "fsl,mpc8323rdb-mmc-slot",
"mmc-spi-slot";
reg = <0>;
gpios = <&qe_pio_d 14 1
&qe_pio_d 15 0>;
voltage-ranges = <3300 3300>;
spi-max-frequency = <50000000>;
};