2
0
mirror of https://github.com/edk2-porting/linux-next.git synced 2024-12-24 13:13:57 +08:00
linux-next/drivers/usb/image/Kconfig
Florian Fainelli 25e11ec4fe USB: regroup all depends on USB within an if USB block
This patch removes the depends on USB from all config symbols in
drivers/usb/host/Kconfig and replace that with an if USB / endif block
as suggested by Alan Stern. Some source ... Kconfig lines have been
shuffled around to permit a better regroupment of the Kconfig files
depending on "config USB" item. No functionnal change is introduced.

Acked-by: Alan Stern <stern@rowland.harvard.edu>
Signed-off-by: Florian Fainelli <florian@openwrt.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2013-04-09 16:49:07 -07:00

29 lines
1014 B
Plaintext

#
# USB Imaging devices configuration
#
comment "USB Imaging devices"
config USB_MDC800
tristate "USB Mustek MDC800 Digital Camera support"
---help---
Say Y here if you want to connect this type of still camera to
your computer's USB port. This driver can be used with gphoto 0.4.3
and higher (look at <http://www.gphoto.org/>).
To use it create a device node with "mknod /dev/mustek c 180 32" and
configure it in your software.
To compile this driver as a module, choose M here: the
module will be called mdc800.
config USB_MICROTEK
tristate "Microtek X6USB scanner support"
depends on SCSI
help
Say Y here if you want support for the Microtek X6USB and
possibly the Phantom 336CX, Phantom C6 and ScanMaker V6U(S)L.
Support for anything but the X6 is experimental.
Please report failures and successes.
The scanner will appear as a scsi generic device to the rest
of the system. Scsi support is required.
This driver can be compiled as a module, called microtek.