mirror of
https://github.com/edk2-porting/linux-next.git
synced 2024-12-26 06:04:14 +08:00
27d868b5e6
Firmware typically configures the PCIe fabric with a consistent Max Payload Size setting based on the devices present at boot. A hot-added device typically has the power-on default MPS setting (128 bytes), which may not match the fabric. The previous Linux default, in the absence of any "pci=pcie_bus_*" options, was PCIE_BUS_TUNE_OFF, in which we never touch MPS, even for hot-added devices. Add a new default setting, PCIE_BUS_DEFAULT, in which we make sure every device's MPS setting matches the upstream bridge. This makes it more likely that a hot-added device will work in a system with optimized MPS configuration. Note that if we hot-add a device that only supports 128-byte MPS, it still likely won't work because we don't reconfigure the rest of the fabric. Booting with "pci=pcie_bus_peer2peer" is a workaround for this because it sets MPS to 128 for everything. [bhelgaas: changelog, new default, rework for pci_configure_device() path] Tested-by: Keith Busch <keith.busch@intel.com> Tested-by: Jordan Hargrave <jharg93@gmail.com> Signed-off-by: Keith Busch <keith.busch@intel.com> Signed-off-by: Bjorn Helgaas <bhelgaas@google.com> Acked-by: Yinghai Lu <yinghai@kernel.org> |
||
|---|---|---|
| .. | ||
| host | ||
| hotplug | ||
| pcie | ||
| access.c | ||
| ats.c | ||
| bus.c | ||
| host-bridge.c | ||
| hotplug-pci.c | ||
| htirq.c | ||
| iov.c | ||
| irq.c | ||
| Kconfig | ||
| Makefile | ||
| msi.c | ||
| of.c | ||
| pci-acpi.c | ||
| pci-driver.c | ||
| pci-label.c | ||
| pci-stub.c | ||
| pci-sysfs.c | ||
| pci.c | ||
| pci.h | ||
| probe.c | ||
| proc.c | ||
| quirks.c | ||
| remove.c | ||
| rom.c | ||
| search.c | ||
| setup-bus.c | ||
| setup-irq.c | ||
| setup-res.c | ||
| slot.c | ||
| syscall.c | ||
| vc.c | ||
| vpd.c | ||
| xen-pcifront.c | ||