mirror of
https://github.com/edk2-porting/linux-next.git
synced 2024-12-21 19:53:59 +08:00
1a613626d2
On a board that needs to drive RTS GPIO high in order to enable the
transmission of a RS485 transceiver the following description is
passed in the devide tree:
&uart4 {
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_uart4>;
rts-gpios = <&gpio6 2 GPIO_ACTIVE_HIGH>;
status = "okay";
};
and userspace configures the uart port as follows:
/* enable RS485 mode: */
rs485conf.flags |= SER_RS485_ENABLED;
/* set logical level for RTS pin equal to 1 when sending: */
rs485conf.flags |= SER_RS485_RTS_ON_SEND;
/* set logical level for RTS pin equal to 0 after sending: */
rs485conf.flags &= ~(SER_RS485_RTS_AFTER_SEND);
However the RTS GPIO polarity observed in the oscilloscope is inverted.
When the SER_RS485_RTS_ON_SEND flag is set the imx_port_rts_active()
function should be called and following the same logic when
SER_RS485_RTS_AFTER_SEND flag is cleared the imx_port_rts_inactive()
should be called.
Do such logic change so that RS485 communication in half duplex can
work successfully when the RTS GPIO pin is passed via device tree.
Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
|
||
|---|---|---|
| .. | ||
| hvc | ||
| ipwireless | ||
| serial | ||
| vt | ||
| amiserial.c | ||
| bfin_jtag_comm.c | ||
| cyclades.c | ||
| ehv_bytechan.c | ||
| goldfish.c | ||
| isicom.c | ||
| Kconfig | ||
| Makefile | ||
| metag_da.c | ||
| mips_ejtag_fdc.c | ||
| moxa.c | ||
| moxa.h | ||
| mxser.c | ||
| mxser.h | ||
| n_gsm.c | ||
| n_hdlc.c | ||
| n_r3964.c | ||
| n_tracerouter.c | ||
| n_tracesink.c | ||
| n_tracesink.h | ||
| n_tty.c | ||
| nozomi.c | ||
| pty.c | ||
| rocket_int.h | ||
| rocket.c | ||
| rocket.h | ||
| synclink_gt.c | ||
| synclink.c | ||
| synclinkmp.c | ||
| sysrq.c | ||
| tty_audit.c | ||
| tty_buffer.c | ||
| tty_io.c | ||
| tty_ioctl.c | ||
| tty_ldisc.c | ||
| tty_ldsem.c | ||
| tty_mutex.c | ||
| tty_port.c | ||