2
0
mirror of https://github.com/edk2-porting/linux-next.git synced 2024-12-25 05:34:00 +08:00
linux-next/net/x25/Kconfig
Sam Ravnborg 6a2e9b738c [NET]: move config options out to individual protocols
Move the protocol specific config options out to the specific protocols.
With this change net/Kconfig now starts to become readable and serve as a
good basis for further re-structuring.

The menu structure is left almost intact, except that indention is
fixed in most cases. Most visible are the INET changes where several
"depends on INET" are replaced with a single ifdef INET / endif pair.

Several new files were created to accomplish this change - they are
small but serve the purpose that config options are now distributed
out where they belongs.

Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
2005-07-11 21:13:56 -07:00

37 lines
1.6 KiB
Plaintext

#
# CCITT X.25 Packet Layer
#
config X25
tristate "CCITT X.25 Packet Layer (EXPERIMENTAL)"
depends on EXPERIMENTAL
---help---
X.25 is a set of standardized network protocols, similar in scope to
frame relay; the one physical line from your box to the X.25 network
entry point can carry several logical point-to-point connections
(called "virtual circuits") to other computers connected to the X.25
network. Governments, banks, and other organizations tend to use it
to connect to each other or to form Wide Area Networks (WANs). Many
countries have public X.25 networks. X.25 consists of two
protocols: the higher level Packet Layer Protocol (PLP) (say Y here
if you want that) and the lower level data link layer protocol LAPB
(say Y to "LAPB Data Link Driver" below if you want that).
You can read more about X.25 at <http://www.sangoma.com/x25.htm> and
<http://www.cisco.com/univercd/cc/td/doc/product/software/ios11/cbook/cx25.htm>.
Information about X.25 for Linux is contained in the files
<file:Documentation/networking/x25.txt> and
<file:Documentation/networking/x25-iface.txt>.
One connects to an X.25 network either with a dedicated network card
using the X.21 protocol (not yet supported by Linux) or one can do
X.25 over a standard telephone line using an ordinary modem (say Y
to "X.25 async driver" below) or over Ethernet using an ordinary
Ethernet card and the LAPB over Ethernet (say Y to "LAPB Data Link
Driver" and "LAPB over Ethernet driver" below).
To compile this driver as a module, choose M here: the module
will be called x25. If unsure, say N.