2
0
mirror of https://github.com/edk2-porting/linux-next.git synced 2024-12-23 12:43:55 +08:00
linux-next/Documentation/devicetree/bindings/extcon/extcon-usb-gpio.txt
Roger Quadros 541332a13b extcon: usb-gpio: Add VBUS detection support
Driver can now work with both ID and VBUS pins or either one of
them.

There can be the following 3 cases

1) Both ID and VBUS GPIOs are available:

ID = LOW -> USB_HOST active, USB inactive
ID = HIGH -> USB_HOST inactive, USB state is same as VBUS.

2) Only ID GPIO is available:

ID = LOW -> USB_HOST active, USB inactive
ID = HIGH -> USB_HOST inactive, USB active

3) Only VBUS GPIO is available:

VBUS = LOW -> USB_HOST inactive, USB inactive
VBUS = HIGH -> USB_HOST inactive, USB active

Signed-off-by: Roger Quadros <rogerq@ti.com>
Reviewed-by: Peter Chen <peter.chen@nxp.com>
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
2016-11-20 21:22:39 +09:00

22 lines
589 B
Plaintext

USB GPIO Extcon device
This is a virtual device used to generate USB cable states from the USB ID pin
connected to a GPIO pin.
Required properties:
- compatible: Should be "linux,extcon-usb-gpio"
Either one of id-gpio or vbus-gpio must be present. Both can be present as well.
- id-gpio: gpio for USB ID pin. See gpio binding.
- vbus-gpio: gpio for USB VBUS pin.
Example: Examples of extcon-usb-gpio node in dra7-evm.dts as listed below:
extcon_usb1 {
compatible = "linux,extcon-usb-gpio";
id-gpio = <&gpio6 1 GPIO_ACTIVE_HIGH>;
}
&omap_dwc3_1 {
extcon = <&extcon_usb1>;
};