The enable_kernel_*() functions leave the relevant MSR bits enabled
until we exit the kernel sometime later. Create disable versions
that wrap the kernel use of FP, Altivec VSX or SPE.
While we don't want to disable it normally for performance reasons
(MSR writes are slow), it will be used for a debug boot option that
does this and catches bad uses in other areas of the kernel.
Signed-off-by: Anton Blanchard <anton@samba.org>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>
Since MD5 IV are now available in crypto/md5.h, use them.
Signed-off-by: LABBE Corentin <clabbe.montjoie@gmail.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
The current cryptodev-2.6 tree commits:
d9850fc529 ("crypto: powerpc/sha1 - kernel config")
50ba29aaa7 ("crypto: powerpc/sha1 - glue")
failed to properly place files under arch/powerpc/crypto, which
leads to build errors:
make[1]: *** No rule to make target 'arch/powerpc/crypto/sha1-spe-asm.o', needed by 'arch/powerpc/crypto/sha1-ppc-spe.o'. Stop.
make[1]: *** No rule to make target 'arch/powerpc/crypto/sha1_spe_glue.o', needed by 'arch/powerpc/crypto/sha1-ppc-spe.o'. Stop.
Makefile:947: recipe for target 'arch/powerpc/crypto' failed
Move the two sha1 spe files under crypto/, and whilst there, rename
other powerpc crypto files with underscores to use dashes for
consistency.
Cc: Markus Stockhausen <stockhausen@collogia.de>
Signed-off-by: Kim Phillips <kim.phillips@freescale.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Integrate the module into the kernel config tree.
Signed-off-by: Markus Stockhausen <stockhausen@collogia.de>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Glue code for crypto infrastructure. Call the assembler
code where required. Take a little care about small input
data. Kick out early for input chunks < 64 bytes and replace
memset for context cleanup with simple loop.
Signed-off-by: Markus Stockhausen <stockhausen@collogia.de>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
This is the assembler code for the MD5 implementation.
Handling of algorithm constants has been slightly
changed to reduce register usage and make better use
of cores with multiple ALUs. Thus they are stored as
delta values.
Signed-off-by: Markus Stockhausen <stockhausen@collogia.de>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Integrate the module into the kernel config tree.
Signed-off-by: Markus Stockhausen <stockhausen@collogia.de>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Integrate the module into the kernel configuration
Signed-off-by: Markus Stockhausen <stockhausen@collogia.de>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Integrate the assembler modules into the kernel crypto
framework. Take care to avoid long intervals of disabled
preemption.
Signed-off-by: Markus Stockhausen <stockhausen@collogia.de>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
The assembler block cipher module that controls the core
AES functions.
Signed-off-by: Markus Stockhausen <stockhausen@collogia.de>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Key generation for big endian core routines.
Signed-off-by: Markus Stockhausen <stockhausen@collogia.de>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
The assembler AES encryption and decryption core routines.
Implemented & optimized for big endian. Nevertheless they
work on little endian too.
For most efficient reuse in (higher level) block cipher
routines they are implemented as "fast" call modules without
any stack handling or register saving. The caller must
take care of that part.
Signed-off-by: Markus Stockhausen <stockhausen@collogia.de>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
4K AES tables for big endian. To reduce the possiblity of
timing attacks, the size has been cut to 8KB + 256 bytes
in contrast to 16KB in the generic implementation. That
is not perfect but at least a good tradeoff for CPU limited
router devices.
Signed-off-by: Markus Stockhausen <stockhausen@collogia.de>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Define some register aliases for better readability.
Signed-off-by: Markus Stockhausen <stockhausen@collogia.de>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Integrate the module into the kernel config tree.
Signed-off-by: Markus Stockhausen <stockhausen@collogia.de>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Glue code for crypto infrastructure. Call the assembler
code where required. Disable preemption during calculation
and enable SPE instructions in the kernel prior to the
call. Avoid to disable preemption for too long.
Take a little care about small input data. Kick out early
for input chunks < 64 bytes and replace memset for context
cleanup with simple loop.
Signed-off-by: Markus Stockhausen <stockhausen@collogia.de>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
This is the assembler code for SHA256 implementation with
the SIMD SPE instruction set. Although being only a 32 bit
architecture GPRs are extended to 64 bit presenting two
32 bit values. With the enhanced instruction set we can
operate on them in parallel. That helps reducing the time
to calculate W16-W64. For increasing performance even more
the assembler function can compute hashes for more than
one 64 byte input block. That saves a lot of register
saving/restoring
The state of the used SPE registers is preserved via the
stack so we can run from interrupt context. There might
be the case that we interrupt ourselves and push sensitive
data from another context onto our stack. Clear this area
in the stack afterwards to avoid information leakage.
The code is endian independant.
Signed-off-by: Markus Stockhausen <stockhausen@collogia.de>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Commit 5d26a105b5 ("crypto: prefix module autoloading with "crypto-"")
changed the automatic module loading when requesting crypto algorithms
to prefix all module requests with "crypto-". This requires all crypto
modules to have a crypto specific module alias even if their file name
would otherwise match the requested crypto algorithm.
Even though commit 5d26a105b5 added those aliases for a vast amount of
modules, it was missing a few. Add the required MODULE_ALIAS_CRYPTO
annotations to those files to make them get loaded automatically, again.
This fixes, e.g., requesting 'ecb(blowfish-generic)', which used to work
with kernels v3.18 and below.
Also change MODULE_ALIAS() lines to MODULE_ALIAS_CRYPTO(). The former
won't work for crypto modules any more.
Fixes: 5d26a105b5 ("crypto: prefix module autoloading with "crypto-"")
Cc: Kees Cook <keescook@chromium.org>
Signed-off-by: Mathias Krause <minipli@googlemail.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Memset on a local variable may be removed when it is called just before the
variable goes out of scope. Using memzero_explicit defeats this
optimization. A simplified version of the semantic patch that makes this
change is as follows: (http://coccinelle.lip6.fr/)
// <smpl>
@@
identifier x;
type T;
@@
{
... when any
T x[...];
... when any
when exists
- memset
+ memzero_explicit
(x,
-0,
...)
... when != x
when strict
}
// </smpl>
This change was suggested by Daniel Borkmann <dborkman@redhat.com>
Signed-off-by: Julia Lawall <Julia.Lawall@lip6.fr>
Acked-by: Michael Ellerman <mpe@ellerman.id.au>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
This prefixes all crypto module loading with "crypto-" so we never run
the risk of exposing module auto-loading to userspace via a crypto API,
as demonstrated by Mathias Krause:
https://lkml.org/lkml/2013/3/4/70
Signed-off-by: Kees Cook <keescook@chromium.org>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
When building with CRYPTO_SHA1_PPC enabled we fail with:
powerpc/crypto/sha1-powerpc-asm.S: Assembler messages:
powerpc/crypto/sha1-powerpc-asm.S:116: Error: can't resolve `0' {*ABS* section} - `STACKFRAMESIZE' {*UND* section}
powerpc/crypto/sha1-powerpc-asm.S:116: Error: expression too complex
powerpc/crypto/sha1-powerpc-asm.S:178: Error: unsupported relocation against STACKFRAMESIZE
Use INT_FRAME_SIZE instead of STACKFRAMESIZE.
Signed-off-by: Tony Breeds <tony@bakeyournoodle.com>
Tested-by: Christian Kujau <lists@nerdbynature.de>
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
This patch adds a crypto driver which provides a powerpc accelerated
implementation of SHA-1, accelerated in that it is written in asm.
Original patch by Paul, minor fixups for upstream by moi.
Lightly tested on 64-bit with the test program here:
http://michael.ellerman.id.au/files/junkcode/sha1test.c
Seems to work, and is "not slower" than the generic version.
Needs testing on 32-bit.
Signed-off-by: Paul Mackerras <paulus@samba.org>
Signed-off-by: Michael Ellerman <michael@ellerman.id.au>
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
