Most NFS server implementations allow up to 64KB reads and writes on the
wire. The Solaris NFS server allows up to a megabyte, for instance.
Now the Linux NFS client supports transfer sizes up to 1MB, too. This will
help reduce protocol and context switch overhead on read/write intensive NFS
workloads, and support larger atomic read and write operations on servers
that support them.
Test-plan:
Connectathon and iozone on mount point with wsize=rsize>32768 over TCP.
Tests with NFS over UDP to verify the maximum RPC payload size cap.
Signed-off-by: Chuck Lever <cel@netapp.com>
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
To help NFS users and server developers, make the "inode number mismatch"
message display more useful information.
Test-plan:
None.
Signed-off-by: Chuck Lever <cel@netapp.com>
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
nfs_statfs() generates a log message when GETATTR returns an error. This
is usually a useless message. Make it a dprintk.
Test plan:
None
Signed-off-by: Chuck Lever <cel@netapp.com>
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
Minor cleanup: inlined bit ops in nfs_page.h can be simpler.
Test plan:
Write-intensive workload against a server that requires COMMITs.
Signed-off-by: Chuck Lever <cel@netapp.com>
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
Red Hat found a problem in the error recovery logic in __init_nfs.
Signed-off-by: Chuck Lever <cel@netapp.com>
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
Replace ad hoc write parameter sanity checking in nfs_file_direct_write()
with a call to generic_write_checks(). This should make the proper checks
modulo the O_LARGEFILE flag, and should catch NFSv2-specific limitations by
virtue of i_sb->s_maxbytes.
Test plan:
Posix compliance testing with both NFSv2 and NFSv3.
Signed-off-by: Chuck Lever <cel@netapp.com>
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
In RFC3530, the RENEW operation is allowed to use either
the same principal, RPC security flavour and (if RPCSEC_GSS), the same
mechanism and service that was used for SETCLIENTID_CONFIRM
OR
Any principal, RPC security flavour and service combination that
currently has an OPEN file on the server.
Choose the latter since that doesn't require us to keep credentials for
the same principal for the entire duration of the mount.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
Convert private implementations in NFSv4 state recovery and delegation
code to use kthreads.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
...and make sure that the "intr" flag also enables SIGHUP and SIGTERM to
interrupt RPC calls too (as per the Solaris implementation).
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
When recovering from a delegation recall or a network partition, we need
to replay open(O_RDWR), open(O_RDONLY) and open(O_WRONLY) separately.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
A closer reading of RFC3530 reveals that OPEN_DOWNGRADE must always
specify a access modes that have been the argument of a previous OPEN
operation.
IOW: doing OPEN(O_RDWR) and then OPEN_DOWNGRADE(O_WRONLY) is forbidden
unless the user called OPEN(O_WRONLY)
In order to fix that, we really need to track the three possible open
states separately.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
OPEN is a stateful operation, so we must ensure that it always
completes. In order to allow users to interrupt the operation,
we need to make the RPC call asynchronous, and then wait on
completion (or cancel).
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
The NFSv4 model requires us to complete all RPC calls that might
establish state on the server whether or not the user wants to
interrupt it. We may also need to schedule new work (including
new RPC calls) in order to cancel the new state.
The asynchronous RPC model will allow us to ensure that RPC calls
always complete, but in order to allow for "synchronous" RPC, we
want to add the ability to wait for completion.
The waits are, of course, interruptible.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
Shrink the RPC task structure. Instead of storing separate pointers
for task->tk_exit and task->tk_release, put them in a structure.
Also pass the user data pointer as a parameter instead of passing it via
task->tk_calldata. This enables us to nest callbacks.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
Ensure that we always initiate flushing of data before we exit
a single-page ->writepage() call.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
NFS needs to be able to distinguish between single-page ->writepage() calls and
multipage ->writepages() calls.
For the single-page writepage calls NFS can kick off the I/O within the
context of ->writepage().
For multipage ->writepages calls, nfs_writepage() will leave the I/O pending
and nfs_writepages() will kick off the I/O when it all has been queued up
within NFS.
Cc: Trond Myklebust <trond.myklebust@fys.uio.no>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
This was harmless, but for the case of a device that had no irq
pre-defined we would incorrectly suggest that "usepirqmask" might make a
difference. It never would, and the message was just confusing people.
Reported in the dmesg of Etienne Lorrain.
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
This patch adds suspend patch to libata, and ata_piix in particular. For
most low level drivers, they should just need to add the 4 hooks to
work. As I can only test ata_piix, I didn't enable it for more
though.
Suspend support is the single most important feature on a notebook, and
most new notebooks have sata drives. It's quite embarrassing that we
_still_ do not support this. Right now, it's perfectly possible to
suspend the drive in mid-transfer.
Signed-off-by: Jens Axboe <axboe@suse.de>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Also export current (average) speed and status in sysfs.
Signed-off-by: Neil Brown <neilb@suse.de>
Acked-by: Greg KH <greg@kroah.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Writing major:minor to md/new_dev will bind that device to the array.
Signed-off-by: Neil Brown <neilb@suse.de>
Acked-by: Greg KH <greg@kroah.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
drivers/md/md.c: In function `offset_show':
drivers/md/md.c:1670: warning: long long unsigned int format, different type arg (arg 3)
Cc: Neil Brown <neilb@suse.de>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
This the role that a device has in an array can be viewed and set.
Signed-off-by: Neil Brown <neilb@suse.de>
Acked-by: Greg KH <greg@kroah.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Move the checks - that dev size is never less than array size - into
bind_rdev_to_array to make sure it always happens properly (there is one place
where currently it doesn't).
Also reject any superblock which claims an array size smaller than the device
in question can hold.
Signed-off-by: Neil Brown <neilb@suse.de>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
If array is active, try to reshape, else just set the value.
Signed-off-by: Neil Brown <neilb@suse.de>
Acked-by: Greg KH <greg@kroah.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Store this total in superblock (As appropriate), and make it available to
userspace via sysfs.
Signed-off-by: Neil Brown <neilb@suse.de>
Acked-by: Greg KH <greg@kroah.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Allow it to be set to a particular version, or 'none'.
Signed-off-by: Neil Brown <neilb@suse.de>
Acked-by: Greg KH <greg@kroah.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
... only before array is started of course.
Signed-off-by: Neil Brown <neilb@suse.de>
Acked-by: Greg KH <greg@kroah.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
When we do a user-requested check/repair, we lose count of the outstanding
requests...
Also make sure that when anything is written to md/sync_action, the
RECOVERY_NEEDED flag is set and the thread is woken up so any changes take
effect.
Signed-off-by: Neil Brown <neilb@suse.de>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
When we update a page_cache page in the kernel, we need to flush_dache_page or
userspace might not see the change.
Signed-off-by: Neil Brown <neilb@suse.de>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Make the needlessly global function md_new_event() static.
Signed-off-by: Adrian Bunk <bunk@stusta.de>
Cc: Neil Brown <neilb@cse.unsw.edu.au>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
.. because they aren't used outside md.c
Signed-off-by: Neil Brown <neilb@suse.de>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>