2
0
mirror of https://github.com/edk2-porting/linux-next.git synced 2024-12-19 02:34:01 +08:00

mtd: rawnand: Deprecate ->block_{bad,markbad}() hooks

Those hooks have been overloaded by some drivers for bad reasons:
either the driver was not fitting in the NAND framework and should
have been an MTD driver (docg4), or it was not properly implementing
the OOB read/write request or had a weird layout where BBM are trashed.
In any case, we should discourage people from overloading those
methods and encourage them to fix their driver instead.

Move the ->block_{bad,markbad}() hooks to the nand_legacy struct to
make it clear.

Signed-off-by: Boris Brezillon <boris.brezillon@bootlin.com>
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
This commit is contained in:
Boris Brezillon 2018-09-07 00:38:38 +02:00 committed by Miquel Raynal
parent 8395b753d7
commit cdc784c743
8 changed files with 40 additions and 22 deletions

View File

@ -719,7 +719,7 @@ static int cafe_nand_probe(struct pci_dev *pdev,
if (skipbbt) {
cafe->nand.options |= NAND_SKIP_BBTSCAN;
cafe->nand.block_bad = cafe_nand_block_bad;
cafe->nand.legacy.block_bad = cafe_nand_block_bad;
}
if (numtimings && numtimings != 3) {

View File

@ -1572,7 +1572,7 @@ static int __init doc_probe(unsigned long physadr)
nand->legacy.cmd_ctrl = doc200x_hwcontrol;
nand->legacy.dev_ready = doc200x_dev_ready;
nand->legacy.waitfunc = doc200x_wait;
nand->block_bad = doc200x_block_bad;
nand->legacy.block_bad = doc200x_block_bad;
nand->ecc.hwctl = doc200x_enable_hwecc;
nand->ecc.calculate = doc200x_calculate_ecc;
nand->ecc.correct = doc200x_correct_data;

View File

@ -1774,7 +1774,7 @@ static int mx23_boot_init(struct gpmi_nand_data *this)
*/
if (block_mark != 0xff) {
dev_dbg(dev, "Transcribing mark in block %u\n", block);
ret = chip->block_markbad(chip, byte);
ret = chip->legacy.block_markbad(chip, byte);
if (ret)
dev_err(dev,
"Failed to mark block bad with ret %d\n",
@ -1908,7 +1908,7 @@ static int gpmi_nand_init(struct gpmi_nand_data *this)
chip->legacy.read_buf = gpmi_read_buf;
chip->legacy.write_buf = gpmi_write_buf;
chip->badblock_pattern = &gpmi_bbt_descr;
chip->block_markbad = gpmi_block_markbad;
chip->legacy.block_markbad = gpmi_block_markbad;
chip->options |= NAND_NO_SUBPAGE_WRITE;
/* Set up swap_block_mark, must be set before the gpmi_set_geometry() */

View File

@ -475,6 +475,27 @@ static int nand_default_block_markbad(struct nand_chip *chip, loff_t ofs)
return ret;
}
/**
* nand_markbad_bbm - mark a block by updating the BBM
* @chip: NAND chip object
* @ofs: offset of the block to mark bad
*/
int nand_markbad_bbm(struct nand_chip *chip, loff_t ofs)
{
if (chip->legacy.block_markbad)
return chip->legacy.block_markbad(chip, ofs);
return nand_default_block_markbad(chip, ofs);
}
static int nand_isbad_bbm(struct nand_chip *chip, loff_t ofs)
{
if (chip->legacy.block_bad)
return chip->legacy.block_bad(chip, ofs);
return nand_block_bad(chip, ofs);
}
/**
* nand_block_markbad_lowlevel - mark a block bad
* @mtd: MTD device structure
@ -482,7 +503,7 @@ static int nand_default_block_markbad(struct nand_chip *chip, loff_t ofs)
*
* This function performs the generic NAND bad block marking steps (i.e., bad
* block table(s) and/or marker(s)). We only allow the hardware driver to
* specify how to write bad block markers to OOB (chip->block_markbad).
* specify how to write bad block markers to OOB (chip->legacy.block_markbad).
*
* We try operations in the following order:
*
@ -510,7 +531,7 @@ static int nand_block_markbad_lowlevel(struct mtd_info *mtd, loff_t ofs)
/* Write bad block marker to OOB */
nand_get_device(mtd, FL_WRITING);
ret = chip->block_markbad(chip, ofs);
ret = nand_markbad_bbm(chip, ofs);
nand_release_device(mtd);
}
@ -582,11 +603,11 @@ static int nand_block_checkbad(struct mtd_info *mtd, loff_t ofs, int allowbbt)
{
struct nand_chip *chip = mtd_to_nand(mtd);
if (!chip->bbt)
return chip->block_bad(chip, ofs);
/* Return info from the table */
return nand_isbad_bbt(chip, ofs, allowbbt);
if (chip->bbt)
return nand_isbad_bbt(chip, ofs, allowbbt);
return nand_isbad_bbm(chip, ofs);
}
/**
@ -4942,10 +4963,6 @@ static void nand_set_defaults(struct nand_chip *chip)
/* If called twice, pointers that depend on busw may need to be reset */
if (!chip->legacy.read_byte || chip->legacy.read_byte == nand_read_byte)
chip->legacy.read_byte = busw ? nand_read_byte16 : nand_read_byte;
if (!chip->block_bad)
chip->block_bad = nand_block_bad;
if (!chip->block_markbad)
chip->block_markbad = nand_default_block_markbad;
if (!chip->legacy.write_buf || chip->legacy.write_buf == nand_write_buf)
chip->legacy.write_buf = busw ? nand_write_buf16 : nand_write_buf;
if (!chip->legacy.write_byte || chip->legacy.write_byte == nand_write_byte)

View File

@ -689,7 +689,7 @@ static void mark_bbt_block_bad(struct nand_chip *this,
bbt_mark_entry(this, block, BBT_BLOCK_WORN);
to = (loff_t)block << this->bbt_erase_shift;
res = this->block_markbad(this, to);
res = nand_markbad_bbm(this, to);
if (res)
pr_warn("nand_bbt: error %d while marking block %d bad\n",
res, block);

View File

@ -2819,8 +2819,8 @@ static int qcom_nand_host_init_and_register(struct qcom_nand_controller *nandc,
* and block_markbad helpers until we permanently switch to using
* MTD_OPS_RAW for all drivers (with the help of badblockbits)
*/
chip->block_bad = qcom_nandc_block_bad;
chip->block_markbad = qcom_nandc_block_markbad;
chip->legacy.block_bad = qcom_nandc_block_bad;
chip->legacy.block_markbad = qcom_nandc_block_markbad;
chip->controller = &nandc->controller;
chip->options |= NAND_NO_SUBPAGE_WRITE | NAND_USE_BOUNCE_BUFFER |

View File

@ -168,7 +168,7 @@ static int sm_attach_chip(struct nand_chip *chip)
/* Bad block marker position */
chip->badblockpos = 0x05;
chip->badblockbits = 7;
chip->block_markbad = sm_block_markbad;
chip->legacy.block_markbad = sm_block_markbad;
/* ECC layout */
if (mtd->writesize == SM_SECTOR_SIZE)

View File

@ -1187,6 +1187,8 @@ int nand_op_parser_exec_op(struct nand_chip *chip,
* If set to NULL no access to ready/busy is available and the
* ready/busy information is read from the chip status register.
* @waitfunc: hardware specific function for wait on ready.
* @block_bad: check if a block is bad, using OOB markers
* @block_markbad: mark a block bad
*
* If you look at this structure you're already wrong. These fields/hooks are
* all deprecated.
@ -1203,6 +1205,8 @@ struct nand_legacy {
int page_addr);
int (*dev_ready)(struct nand_chip *chip);
int (*waitfunc)(struct nand_chip *chip);
int (*block_bad)(struct nand_chip *chip, loff_t ofs);
int (*block_markbad)(struct nand_chip *chip, loff_t ofs);
};
/**
@ -1214,8 +1218,6 @@ struct nand_legacy {
* fields/hooks, you should consider reworking the driver
* avoid using them.
* @select_chip: [REPLACEABLE] select chip nr
* @block_bad: [REPLACEABLE] check if a block is bad, using OOB markers
* @block_markbad: [REPLACEABLE] mark a block bad
* @exec_op: controller specific method to execute NAND operations.
* This method replaces ->cmdfunc(),
* ->legacy.{read,write}_{buf,byte,word}(),
@ -1303,8 +1305,6 @@ struct nand_chip {
struct nand_legacy legacy;
void (*select_chip)(struct nand_chip *chip, int cs);
int (*block_bad)(struct nand_chip *chip, loff_t ofs);
int (*block_markbad)(struct nand_chip *chip, loff_t ofs);
int (*exec_op)(struct nand_chip *chip,
const struct nand_operation *op,
bool check_only);
@ -1556,6 +1556,7 @@ extern const struct nand_manufacturer_ops macronix_nand_manuf_ops;
int nand_create_bbt(struct nand_chip *chip);
int nand_markbad_bbt(struct nand_chip *chip, loff_t offs);
int nand_markbad_bbm(struct nand_chip *chip, loff_t ofs);
int nand_isreserved_bbt(struct nand_chip *chip, loff_t offs);
int nand_isbad_bbt(struct nand_chip *chip, loff_t offs, int allowbbt);
int nand_erase_nand(struct nand_chip *chip, struct erase_info *instr,