u-boot/configs/Sinovoip_BPI_M3_defconfig
Tom Rini ecad7051b0 configs: Migrate all of the existing USB symbols, except fastboot
This syncs all of the currently Kconfig'd symbols out of the headers and
into the defconfig files.  This has two exceptions, first am335x_evm
needs to be converted to DM in SPL and then it can stop undef'ing
CONFIG_DM_USB.  Leaving this as-is results in a build failure, and
without work, run time failure.  The other case is am43xx_evm.h and in
turn am43xx_evm_usbhost_boot.  The problem here is that we need DWC3 USB
host mode in SPL, but still desire to have gadget mode in U-Boot proper.

Signed-off-by: Tom Rini <trini@konsulko.com>
2017-09-01 16:18:20 -04:00

32 lines
874 B
Plaintext

CONFIG_ARM=y
CONFIG_ARCH_SUNXI=y
CONFIG_MACH_SUN8I_A83T=y
CONFIG_DRAM_TYPE=7
CONFIG_DRAM_CLK=480
CONFIG_DRAM_ZQ=15355
CONFIG_DRAM_ODT_EN=y
CONFIG_INITIAL_USB_SCAN_DELAY=500
CONFIG_USB0_VBUS_PIN="AXP0-VBUS-ENABLE"
CONFIG_USB0_VBUS_DET="AXP0-VBUS-DETECT"
CONFIG_USB0_ID_DET="PH11"
CONFIG_USB1_VBUS_PIN="PD24"
CONFIG_AXP_GPIO=y
CONFIG_SATAPWR="PD25"
CONFIG_MMC_SUNXI_SLOT_EXTRA=2
CONFIG_DEFAULT_DEVICE_TREE="sun8i-a83t-sinovoip-bpi-m3"
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
CONFIG_CONSOLE_MUX=y
CONFIG_SPL=y
# CONFIG_CMD_IMLS is not set
# CONFIG_CMD_FLASH is not set
# CONFIG_CMD_FPGA is not set
# CONFIG_SPL_DOS_PARTITION is not set
# CONFIG_SPL_ISO_PARTITION is not set
# CONFIG_SPL_EFI_PARTITION is not set
CONFIG_AXP_DCDC5_VOLT=1200
CONFIG_AXP_DLDO3_VOLT=2500
CONFIG_AXP_SW_ON=y
CONFIG_USB_EHCI_HCD=y
CONFIG_USB_MUSB_HOST=y
CONFIG_SYS_USB_EVENT_POLL_VIA_INT_QUEUE=y