u-boot/board/freescale/t208xrdb/t2080_pbi.cfg
Zhao Qiang c5938c10ef pbl: use "wait" command instead of "flush" command
PBL flush command is restricted to CCSR memory space. So use WAIT
PBI command to provide enough time for data to get flush in
target memory.

Signed-off-by: Zhao Qiang <qiang.zhao@nxp.com>
[York Sun: rewrap commit message]
Reviewed-by: York Sun <york.sun@nxp.com>
2016-10-14 10:21:30 -07:00

41 lines
888 B
INI

#
# Copyright 2013 Freescale Semiconductor, Inc.
#
# SPDX-License-Identifier: GPL-2.0+
#
# Refer doc/README.pblimage for more details about how-to configure
# and create PBL boot image
#
#PBI commands
#Initialize CPC1
09010000 00200400
09138000 00000000
091380c0 00000100
#512KB SRAM
09010100 00000000
09010104 fff80009
09010f00 08000000
#enable CPC1
09010000 80000000
#Configure LAW for CPC1
09000d00 00000000
09000d04 fff80000
09000d08 81000012
#Initialize eSPI controller, default configuration is slow for eSPI to
#load data, this configuration comes from u-boot eSPI driver.
09110000 80000403
09110020 2d170008
09110024 00100008
09110028 00100008
0911002c 00100008
#Errata for slowing down the MDC clock to make it <= 2.5 MHZ
094fc030 00008148
094fd030 00008148
#Configure alternate space
09000010 00000000
09000014 ff000000
09000018 81000000
#Flush PBL data
091380c0 00100000