u-boot/drivers/dma/Makefile
Khoronzhuk, Ivan e165b1d34c dma: ti-edma3: introduce edma3 driver
The EDMA3 controller’s primary purpose is to service data transfers
that you program between two memory-mapped slave endpoints on the device.

Typical usage includes, but is not limited to the following:
- Servicing software-driven paging transfers (e.g., transfers from external
  memory, such as SDRAM to internal device memory, such as DSP L2 SRAM)
- Servicing event-driven peripherals, such as a serial port
- Performing sorting or sub-frame extraction of various data structures
- Offloading data transfers from the main device DSP(s)
- See the device-specific data manual for specific peripherals that are
  accessible via the EDMA3 controller

Signed-off-by: Ivan Khoronzhuk <ivan.khoronzhuk@ti.com>
2014-10-23 11:27:29 -04:00

13 lines
357 B
Makefile

#
# (C) Copyright 2006
# Wolfgang Denk, DENX Software Engineering, wd@denx.de.
#
# SPDX-License-Identifier: GPL-2.0+
#
obj-$(CONFIG_FSLDMAFEC) += MCD_tasksInit.o MCD_dmaApi.o MCD_tasks.o
obj-$(CONFIG_APBH_DMA) += apbh_dma.o
obj-$(CONFIG_FSL_DMA) += fsl_dma.o
obj-$(CONFIG_TI_KSNAV) += keystone_nav.o keystone_nav_cfg.o
obj-$(CONFIG_TI_EDMA3) += ti-edma3.o