mirror of
https://github.com/u-boot/u-boot.git
synced 2024-12-04 01:53:27 +08:00
4f67b93fb7
We enabled CONFIG_ISO_PARTITION by default for distro boot, so that U-Boot could load distro images that usually get shipped as iso images. These images usually come with a board agnostic boot environment. However, there is very little point in having ISO support enabled (for anyone really) in SPL, as the whole idea of SPL is to load U-Boot proper which again is board specific. So the fact that we enable ISO support in U-Boot proper does not mean at all that we want ISO support in U-Boot SPL. Hence, let's remove the Kconfig dependency. Along the way, let's also clean up all those default configs that disabled SPL ISO support. Signed-off-by: Alexander Graf <agraf@suse.de>
29 lines
970 B
Plaintext
29 lines
970 B
Plaintext
CONFIG_ARM=y
|
|
CONFIG_ARCH_SUNXI=y
|
|
CONFIG_SPL=y
|
|
CONFIG_MACH_SUN6I=y
|
|
CONFIG_DRAM_CLK=360
|
|
CONFIG_DRAM_ZQ=122
|
|
CONFIG_USB0_VBUS_PIN="AXP0-VBUS-ENABLE"
|
|
CONFIG_USB0_VBUS_DET="AXP0-VBUS-DETECT"
|
|
CONFIG_AXP_GPIO=y
|
|
CONFIG_VIDEO_LCD_MODE="x:768,y:1024,depth:18,pclk_khz:66000,le:56,ri:60,up:30,lo:36,hs:64,vs:50,sync:3,vmode:0"
|
|
CONFIG_VIDEO_LCD_BL_EN="PA25"
|
|
CONFIG_VIDEO_LCD_BL_PWM="PH13"
|
|
CONFIG_VIDEO_LCD_PANEL_MIPI_4_LANE_513_MBPS_VIA_SSD2828=y
|
|
CONFIG_DEFAULT_DEVICE_TREE="sun6i-a31s-primo81"
|
|
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
|
|
# CONFIG_CMD_FLASH is not set
|
|
# CONFIG_SPL_DOS_PARTITION is not set
|
|
# CONFIG_SPL_EFI_PARTITION is not set
|
|
CONFIG_AXP_DLDO1_VOLT=3300
|
|
# CONFIG_REQUIRE_SERIAL_CONSOLE is not set
|
|
CONFIG_USB_MUSB_HOST=y
|
|
CONFIG_SYS_USB_EVENT_POLL_VIA_INT_QUEUE=y
|
|
CONFIG_VIDEO_LCD_SSD2828_TX_CLK=27
|
|
CONFIG_VIDEO_LCD_SSD2828_RESET="PA26"
|
|
CONFIG_VIDEO_LCD_SPI_CS="PH9"
|
|
CONFIG_VIDEO_LCD_SPI_SCLK="PH10"
|
|
CONFIG_VIDEO_LCD_SPI_MOSI="PH11"
|
|
CONFIG_VIDEO_LCD_SPI_MISO="PH12"
|