u-boot/include/configs/ti_armv7_omap.h
Tom Rini 29cb2b3b90 gpio: Move OMAP_GPIO to Kconfig
This driver is used often enough such that we want to have this enabled
by default on any ARCH_OMAP2PLUS board, and this only compiles on
ARCH_OMAP2PLUS due to required defines, so mark that as the depends.

Signed-off-by: Tom Rini <trini@konsulko.com>
2017-05-15 10:40:00 -04:00

40 lines
999 B
C

/*
* ti_armv7_omap.h
*
* Copyright (C) 2015 Texas Instruments Incorporated - http://www.ti.com/
*
* SPDX-License-Identifier: GPL-2.0+
*
* The various ARMv7 SoCs from TI all share a number of IP blocks when
* implementing a given feature. This is meant to isolate the features
* that are based on OMAP architecture.
*/
#ifndef __CONFIG_TI_ARMV7_OMAP_H__
#define __CONFIG_TI_ARMV7_OMAP_H__
/* I2C IP block */
#define CONFIG_SYS_OMAP24_I2C_SPEED 100000
#define CONFIG_SYS_OMAP24_I2C_SLAVE 1
#define CONFIG_SYS_I2C_OMAP24XX
/* SPI IP Block */
#define CONFIG_OMAP3_SPI
/*
* GPMC NAND block. We support 1 device and the physical address to
* access CS0 at is 0x8000000.
*/
#ifdef CONFIG_NAND
#define CONFIG_NAND_OMAP_GPMC
#ifndef CONFIG_SYS_NAND_BASE
#define CONFIG_SYS_NAND_BASE 0x8000000
#endif
#define CONFIG_SYS_MAX_NAND_DEVICE 1
#define CONFIG_CMD_NAND
#endif
/* Now for the remaining common defines */
#include <configs/ti_armv7_common.h>
#endif /* __CONFIG_TI_ARMV7_OMAP_H__ */