u-boot/board/sunxi/gmac.c
Hans de Goede f885b84968 sunxi: Fix gmac not working reliable on the Bananapi
In order for the gmac nic to work reliable on the Bananapi, we need to set
bits 10-12 GTXDC "GMAC Transmit Clock Delay Chain" of the GMAC clk register
(0x01c20164) to 3.

Without this about 9 out of 10 ethernet packets get lost, with this setting
there is no packet loss.

So far setting these bits is only necessary on the Bananapi, so this commit
solves this with a bit of #ifdef CONFIG_BANANAPI code. If in the future we
need to do something similar for other boards, we can create a specific
CONFIG_FOO option for this then.

Reported-by: Karsten Merker <merker@debian.org>
Signed-off-by: Hans de Goede <hdegoede@redhat.com>
Tested-by: Karsten Merker <merker@debian.org>
Tested-by: Zoltan HERPAI <wigyori@openwrt.org>
Tested-by: Tony Zhang <tony.zhang@lemaker.org>
Acked-by: Ian Campbell <ijc@hellion.org.uk>
2014-10-08 11:19:46 -04:00

53 lines
1.3 KiB
C

#include <common.h>
#include <netdev.h>
#include <miiphy.h>
#include <asm/gpio.h>
#include <asm/io.h>
#include <asm/arch/clock.h>
#include <asm/arch/gpio.h>
int sunxi_gmac_initialize(bd_t *bis)
{
int pin;
struct sunxi_ccm_reg *const ccm =
(struct sunxi_ccm_reg *)SUNXI_CCM_BASE;
/* Set up clock gating */
setbits_le32(&ccm->ahb_gate1, 0x1 << AHB_GATE_OFFSET_GMAC);
/* Set MII clock */
#ifdef CONFIG_RGMII
setbits_le32(&ccm->gmac_clk_cfg, CCM_GMAC_CTRL_TX_CLK_SRC_INT_RGMII |
CCM_GMAC_CTRL_GPIT_RGMII);
#else
setbits_le32(&ccm->gmac_clk_cfg, CCM_GMAC_CTRL_TX_CLK_SRC_MII |
CCM_GMAC_CTRL_GPIT_MII);
#endif
/*
* In order for the gmac nic to work reliable on the Bananapi, we
* need to set bits 10-12 GTXDC "GMAC Transmit Clock Delay Chain"
* of the GMAC clk register to 3.
*/
#ifdef CONFIG_BANANAPI
setbits_le32(&ccm->gmac_clk_cfg, 0x3 << 10);
#endif
/* Configure pin mux settings for GMAC */
for (pin = SUNXI_GPA(0); pin <= SUNXI_GPA(16); pin++) {
#ifdef CONFIG_RGMII
/* skip unused pins in RGMII mode */
if (pin == SUNXI_GPA(9) || pin == SUNXI_GPA(14))
continue;
#endif
sunxi_gpio_set_cfgpin(pin, SUN7I_GPA0_GMAC);
sunxi_gpio_set_drv(pin, 3);
}
#ifdef CONFIG_RGMII
return designware_initialize(SUNXI_GMAC_BASE, PHY_INTERFACE_MODE_RGMII);
#else
return designware_initialize(SUNXI_GMAC_BASE, PHY_INTERFACE_MODE_MII);
#endif
}