u-boot/configs/j721e_evm_r5_defconfig
Tom Rini a09fea1d28 env: Finish migration of common ENV options
- In ARMv8 NXP Layerscape platforms we also need to make use of
  CONFIG_SYS_RELOC_GD_ENV_ADDR now, do so.
- On ENV_IS_IN_REMOTE, CONFIG_ENV_OFFSET is never used, drop the define
  to 0.
- Add Kconfig entry for ENV_ADDR.
- Make ENV_ADDR / ENV_OFFSET depend on the env locations that use it.
- Add ENV_xxx_REDUND options that depend on their primary option and
  SYS_REDUNDAND_ENVIRONMENT
- On a number of PowerPC platforms, use SPL_ENV_ADDR not CONFIG_ENV_ADDR
  for the pre-main-U-Boot environment location.
- On ENV_IS_IN_SPI_FLASH, check not for CONFIG_ENV_ADDR being set but
  rather it being non-zero, as it will now be zero by default.
- Rework the env_offset absolute in env/embedded.o to not use
  CONFIG_ENV_OFFSET as it was the only use of ENV_OFFSET within
  ENV_IS_IN_FLASH.
- Migrate all platforms.

Cc: Wolfgang Denk <wd@denx.de>
Cc: Joe Hershberger <joe.hershberger@ni.com>
Cc: Patrick Delaunay <patrick.delaunay@st.com>
Cc: uboot-stm32@st-md-mailman.stormreply.com
Signed-off-by: Tom Rini <trini@konsulko.com>
Acked-by: Joe Hershberger <joe.hershberger@ni.com>
Reviewed-by: Simon Goldschmidt <simon.k.r.goldschmidt@gmail.com>
2019-11-20 18:32:09 -05:00

103 lines
2.4 KiB
Plaintext

CONFIG_ARM=y
CONFIG_ARCH_K3=y
CONFIG_SPL_GPIO_SUPPORT=y
CONFIG_SPL_LIBCOMMON_SUPPORT=y
CONFIG_SPL_LIBGENERIC_SUPPORT=y
CONFIG_SYS_MALLOC_F_LEN=0x55000
CONFIG_SOC_K3_J721E=y
CONFIG_TARGET_J721E_R5_EVM=y
CONFIG_SPL_MMC_SUPPORT=y
CONFIG_SPL_SERIAL_SUPPORT=y
CONFIG_SPL_DRIVERS_MISC_SUPPORT=y
CONFIG_ENV_SIZE=0x20000
CONFIG_SPL_STACK_R_ADDR=0x82000000
CONFIG_SPL_FS_FAT=y
CONFIG_SPL_LIBDISK_SUPPORT=y
CONFIG_SPL_SPI_FLASH_SUPPORT=y
CONFIG_SPL_SPI_SUPPORT=y
CONFIG_SPL_TEXT_BASE=0x41c00000
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
CONFIG_SPL_LOAD_FIT=y
CONFIG_USE_BOOTCOMMAND=y
# CONFIG_DISPLAY_CPUINFO is not set
CONFIG_SPL_STACK_R=y
CONFIG_SPL_SEPARATE_BSS=y
CONFIG_SPL_EARLY_BSS=y
CONFIG_SPL_ENV_SUPPORT=y
CONFIG_SPL_I2C_SUPPORT=y
CONFIG_SPL_DM_MAILBOX=y
CONFIG_SPL_DM_RESET=y
CONFIG_SPL_POWER_SUPPORT=y
CONFIG_SPL_POWER_DOMAIN=y
CONFIG_SPL_RAM_SUPPORT=y
CONFIG_SPL_RAM_DEVICE=y
CONFIG_SPL_REMOTEPROC=y
CONFIG_SPL_SPI_LOAD=y
CONFIG_SYS_SPI_U_BOOT_OFFS=0x80000
CONFIG_SPL_YMODEM_SUPPORT=y
CONFIG_HUSH_PARSER=y
# CONFIG_CMD_FLASH is not set
CONFIG_CMD_GPT=y
CONFIG_CMD_MMC=y
CONFIG_CMD_REMOTEPROC=y
# CONFIG_CMD_SETEXPR is not set
CONFIG_CMD_TIME=y
CONFIG_CMD_FAT=y
CONFIG_OF_CONTROL=y
CONFIG_SPL_OF_CONTROL=y
CONFIG_DEFAULT_DEVICE_TREE="k3-j721e-r5-common-proc-board"
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
CONFIG_DM=y
CONFIG_SPL_DM=y
CONFIG_SPL_DM_SEQ_ALIAS=y
CONFIG_REGMAP=y
CONFIG_SPL_REGMAP=y
CONFIG_SPL_OF_TRANSLATE=y
CONFIG_CLK=y
CONFIG_SPL_CLK=y
CONFIG_CLK_TI_SCI=y
CONFIG_TI_SCI_PROTOCOL=y
CONFIG_DM_GPIO=y
CONFIG_DA8XX_GPIO=y
CONFIG_DM_I2C=y
CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
CONFIG_SYS_I2C_OMAP24XX=y
CONFIG_DM_MAILBOX=y
CONFIG_K3_SEC_PROXY=y
CONFIG_MISC=y
CONFIG_FS_LOADER=y
CONFIG_K3_AVS0=y
CONFIG_DM_MMC=y
CONFIG_MMC_SDHCI=y
CONFIG_MMC_SDHCI_AM654=y
CONFIG_DM_SPI_FLASH=y
CONFIG_SPI_FLASH_STMICRO=y
CONFIG_PINCTRL=y
# CONFIG_PINCTRL_GENERIC is not set
CONFIG_SPL_PINCTRL=y
# CONFIG_SPL_PINCTRL_GENERIC is not set
CONFIG_PINCTRL_SINGLE=y
CONFIG_POWER_DOMAIN=y
CONFIG_TI_SCI_POWER_DOMAIN=y
CONFIG_DM_PMIC=y
CONFIG_PMIC_TPS65941=y
CONFIG_DM_REGULATOR=y
CONFIG_SPL_DM_REGULATOR=y
CONFIG_DM_REGULATOR_TPS65941=y
CONFIG_K3_SYSTEM_CONTROLLER=y
CONFIG_REMOTEPROC_TI_K3_ARM64=y
CONFIG_DM_RESET=y
CONFIG_RESET_TI_SCI=y
CONFIG_DM_SERIAL=y
CONFIG_SPI=y
CONFIG_DM_SPI=y
CONFIG_CADENCE_QSPI=y
CONFIG_SYSRESET=y
CONFIG_SPL_SYSRESET=y
CONFIG_SYSRESET_TI_SCI=y
CONFIG_TIMER=y
CONFIG_SPL_TIMER=y
CONFIG_OMAP_TIMER=y
CONFIG_FS_EXT4=y
CONFIG_FS_FAT_MAX_CLUSTSIZE=16384