mirror of
https://github.com/u-boot/u-boot.git
synced 2024-12-11 13:43:27 +08:00
6e7df1d151
At this point, the remaining places where we have a symbol that is defined as CONFIG_... are in fairly odd locations. While as much dead code has been removed as possible, some of these locations are simply less obvious at first. In other cases, this code is used, but was defined in such a way as to have been missed by earlier checks. Perform a rename of all such remaining symbols to be CFG_... rather than CONFIG_... Signed-off-by: Tom Rini <trini@konsulko.com> Reviewed-by: Simon Glass <sjg@chromium.org> |
||
|---|---|---|
| .. | ||
| board.c | ||
| board.h | ||
| Kconfig | ||
| MAINTAINERS | ||
| Makefile | ||
| mux.c | ||
| README | ||
# Copyright (C) 2018 EETS GmbH - http://www.eets.ch/ # # SPDX-License-Identifier: GPL-2.0+ # Summary ======= This document covers the PDU001 target. Hardware ======== The PDU-001 (Processor and Display Unit) is a plugin card for 19" racks. It is manufactured by EETS GmbH (https://www.eets.ch). The core of the board is a m2 SOM from bytes at work (https://www.bytesatwork.ch) which in turn is based on AM3352 SOC from TI (http://www.ti.com). Customization ============= As usual the console serial interface is set by CONFIG_CONS_INDEX. Best choice is 4 here since UART3 is wired to the connector K2. The Run LED on the PDU-001 can be turned on red by setting CONFIG_RUN_LED_RED or green by setting CONFIG_RUN_LED_GREEN. Setting CONFIG_RUN_LED_OFF will turn off the Run LED. Booting ======= The system boots from either eMMC or SD card cage. It will first try to boot from the SD card cage. If this fails (missing or unbootable SD card) it will try to boot from the internal eMMC. The root file system is always expected to be located in the second partition of the device (eMMC or SD card) that pro- vided the boot loader.