u-boot/configs/cm_t54_defconfig
Tuomas Tynkkynen ad12dc1844 cmd: Toggle the default value of CONFIG_CMD_IMLS
Having this as a 'default y' is rather annoying because it doesn't
actually compile unless other options are defined in the board header:

../cmd/bootm.c: In function 'do_imls_nor':
../cmd/bootm.c:330:7: error: 'CONFIG_SYS_MAX_FLASH_BANKS' undeclared (first use in this function); did you mean 'CONFIG_SYS_MAX_FLASH_SECT'?
   i < CONFIG_SYS_MAX_FLASH_BANKS; ++i, ++info) {

Make it 'default n' so people who develop new boards that start from a
blank defconfig have one less compilation failure to debug.

Signed-off-by: Tuomas Tynkkynen <tuomas.tynkkynen@iki.fi>
2017-10-10 17:51:04 -04:00

54 lines
1.2 KiB
Plaintext

CONFIG_ARM=y
CONFIG_ARCH_OMAP2PLUS=y
CONFIG_OMAP54XX=y
CONFIG_TARGET_CM_T54=y
CONFIG_OMAP_PLATFORM_RESET_TIME_MAX_USEC=16296
# CONFIG_SPL_NAND_SUPPORT is not set
CONFIG_OF_BOARD_SETUP=y
CONFIG_BOOTDELAY=3
CONFIG_SYS_CONSOLE_INFO_QUIET=y
CONFIG_VERSION_VARIABLE=y
CONFIG_SPL=y
CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0x200
CONFIG_SPL_SATA_SUPPORT=y
CONFIG_HUSH_PARSER=y
CONFIG_SYS_PROMPT="CM-T54 # "
CONFIG_CMD_BOOTZ=y
CONFIG_CMD_ASKENV=y
CONFIG_CMD_EEPROM=y
CONFIG_CMD_EEPROM_LAYOUT=y
CONFIG_EEPROM_LAYOUT_HELP_STRING="v2, v3"
# CONFIG_CMD_FLASH is not set
CONFIG_CMD_GPIO=y
CONFIG_CMD_I2C=y
CONFIG_CMD_MMC=y
CONFIG_CMD_PART=y
CONFIG_CMD_SPI=y
CONFIG_CMD_USB=y
# CONFIG_CMD_SETEXPR is not set
CONFIG_CMD_DHCP=y
# CONFIG_CMD_NFS is not set
CONFIG_CMD_MII=y
CONFIG_CMD_PING=y
CONFIG_CMD_EXT2=y
CONFIG_CMD_EXT4=y
CONFIG_CMD_EXT4_WRITE=y
CONFIG_CMD_FAT=y
CONFIG_CMD_FS_GENERIC=y
CONFIG_ISO_PARTITION=y
CONFIG_EFI_PARTITION=y
CONFIG_ENV_IS_IN_MMC=y
CONFIG_MMC_OMAP_HS=y
CONFIG_SCSI=y
CONFIG_SYS_NS16550=y
CONFIG_OMAP3_SPI=y
CONFIG_USB=y
CONFIG_USB_EHCI_HCD=y
CONFIG_USB_STORAGE=y
CONFIG_USB_HOST_ETHER=y
CONFIG_USB_ETHER_ASIX=y
CONFIG_USB_ETHER_MCS7830=y
CONFIG_USB_ETHER_SMSC95XX=y
CONFIG_FAT_WRITE=y
CONFIG_OF_LIBFDT=y