mirror of
https://github.com/u-boot/u-boot.git
synced 2024-12-26 05:03:30 +08:00
e37ac717d7
Converted to use fsl_esdhc_imx for i.MX platforms. Signed-off-by: Yangbo Lu <yangbo.lu@nxp.com> Tested-by: Steffen Dirkwinkel <s.dirkwinkel@beckhoff.com> Reviewed-by: Peng Fan <peng.fan@nxp.com> Reviewed-by: Lukasz Majewski <lukma@denx.de> Reviewed-by: Martyn Welch <martyn.welch@collabora.com> Acked-by: Jason Liu <Jason.hui.liu@nxp.com> |
||
|---|---|---|
| .. | ||
| imximage.cfg | ||
| Kconfig | ||
| MAINTAINERS | ||
| Makefile | ||
| README | ||
| warp.c | ||
How to Update U-Boot on Warp board ---------------------------------- Required software on the host PC: - imx_usb_loader: https://github.com/boundarydevices/imx_usb_loader - dfu-util: http://dfu-util.sourceforge.net/releases/ Build U-Boot for Warp: $ make mrproper $ make warp_config $ make This will generate the U-Boot binary called u-boot.imx. Put warp board in USB download mode Connect a USB to serial adapter between the host PC and warp Connect a USB cable between the OTG warp port and the host PC Open a terminal program such as minicom Copy u-boot.imx to the imx_usb_loader folder. Load u-boot.imx via USB: $ sudo ./imx_usb u-boot.imx Then U-Boot should start and its messages will appear in the console program. Use the default environment variables: => env default -f -a => saveenv Run the DFU command: => dfu 0 mmc 0 Transfer u-boot.imx that will be flashed into the eMMC: $ sudo dfu-util -D u-boot.imx -a boot Then on the U-Boot prompt the following message should be seen after a successful upgrade: #DOWNLOAD ... OK Ctrl+C to exit ... Remove power from the warp board. Put warp board into normal boot mode Power up the board and the new updated U-Boot should boot from eMMC