mirror of
https://github.com/u-boot/u-boot.git
synced 2024-11-28 07:03:31 +08:00
4f67b93fb7
We enabled CONFIG_ISO_PARTITION by default for distro boot, so that U-Boot could load distro images that usually get shipped as iso images. These images usually come with a board agnostic boot environment. However, there is very little point in having ISO support enabled (for anyone really) in SPL, as the whole idea of SPL is to load U-Boot proper which again is board specific. So the fact that we enable ISO support in U-Boot proper does not mean at all that we want ISO support in U-Boot SPL. Hence, let's remove the Kconfig dependency. Along the way, let's also clean up all those default configs that disabled SPL ISO support. Signed-off-by: Alexander Graf <agraf@suse.de>
29 lines
774 B
Plaintext
29 lines
774 B
Plaintext
CONFIG_ARM=y
|
|
CONFIG_ARCH_SUNXI=y
|
|
CONFIG_SPL=y
|
|
CONFIG_MACH_SUN8I_A83T=y
|
|
CONFIG_DRAM_TYPE=7
|
|
CONFIG_DRAM_CLK=480
|
|
CONFIG_DRAM_ZQ=15355
|
|
CONFIG_DRAM_ODT_EN=y
|
|
CONFIG_MMC_SUNXI_SLOT_EXTRA=2
|
|
CONFIG_INITIAL_USB_SCAN_DELAY=500
|
|
CONFIG_USB0_VBUS_PIN="AXP0-VBUS-ENABLE"
|
|
CONFIG_USB0_VBUS_DET="AXP0-VBUS-DETECT"
|
|
CONFIG_USB0_ID_DET="PH11"
|
|
CONFIG_USB1_VBUS_PIN="PD24"
|
|
CONFIG_AXP_GPIO=y
|
|
CONFIG_SATAPWR="PD25"
|
|
CONFIG_DEFAULT_DEVICE_TREE="sun8i-a83t-bananapi-m3"
|
|
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
|
|
CONFIG_CONSOLE_MUX=y
|
|
# CONFIG_CMD_FLASH is not set
|
|
# CONFIG_SPL_DOS_PARTITION is not set
|
|
# CONFIG_SPL_EFI_PARTITION is not set
|
|
CONFIG_AXP_DCDC5_VOLT=1200
|
|
CONFIG_AXP_DLDO3_VOLT=2500
|
|
CONFIG_AXP_SW_ON=y
|
|
CONFIG_USB_EHCI_HCD=y
|
|
CONFIG_USB_MUSB_HOST=y
|
|
CONFIG_SYS_USB_EVENT_POLL_VIA_INT_QUEUE=y
|