mirror of
https://github.com/u-boot/u-boot.git
synced 2024-12-27 05:33:27 +08:00
34e026f9b1
Mostly reusing DDR3 driver, this patch adds DDR4 SPD handling, register calculation and programming. Signed-off-by: York Sun <yorksun@freescale.com>
121 lines
3.1 KiB
C
121 lines
3.1 KiB
C
/*
|
|
* Copyright 2008-2014 Freescale Semiconductor, Inc.
|
|
*
|
|
* This program is free software; you can redistribute it and/or
|
|
* modify it under the terms of the GNU General Public License
|
|
* Version 2 as published by the Free Software Foundation.
|
|
*/
|
|
|
|
#ifndef DDR2_DIMM_PARAMS_H
|
|
#define DDR2_DIMM_PARAMS_H
|
|
|
|
#define EDC_DATA_PARITY 1
|
|
#define EDC_ECC 2
|
|
#define EDC_AC_PARITY 4
|
|
|
|
/* Parameters for a DDR dimm computed from the SPD */
|
|
typedef struct dimm_params_s {
|
|
|
|
/* DIMM organization parameters */
|
|
char mpart[19]; /* guaranteed null terminated */
|
|
|
|
unsigned int n_ranks;
|
|
unsigned long long rank_density;
|
|
unsigned long long capacity;
|
|
unsigned int data_width;
|
|
unsigned int primary_sdram_width;
|
|
unsigned int ec_sdram_width;
|
|
unsigned int registered_dimm;
|
|
unsigned int device_width; /* x4, x8, x16 components */
|
|
|
|
/* SDRAM device parameters */
|
|
unsigned int n_row_addr;
|
|
unsigned int n_col_addr;
|
|
unsigned int edc_config; /* 0 = none, 1 = parity, 2 = ECC */
|
|
#ifdef CONFIG_SYS_FSL_DDR4
|
|
unsigned int bank_addr_bits;
|
|
unsigned int bank_group_bits;
|
|
#else
|
|
unsigned int n_banks_per_sdram_device;
|
|
#endif
|
|
unsigned int burst_lengths_bitmask; /* BL=4 bit 2, BL=8 = bit 3 */
|
|
unsigned int row_density;
|
|
|
|
/* used in computing base address of DIMMs */
|
|
unsigned long long base_address;
|
|
/* mirrored DIMMs */
|
|
unsigned int mirrored_dimm; /* only for ddr3 */
|
|
|
|
/* DIMM timing parameters */
|
|
|
|
int mtb_ps; /* medium timebase ps */
|
|
int ftb_10th_ps; /* fine timebase, in 1/10 ps */
|
|
int taa_ps; /* minimum CAS latency time */
|
|
int tfaw_ps; /* four active window delay */
|
|
|
|
/*
|
|
* SDRAM clock periods
|
|
* The range for these are 1000-10000 so a short should be sufficient
|
|
*/
|
|
int tckmin_x_ps;
|
|
int tckmin_x_minus_1_ps;
|
|
int tckmin_x_minus_2_ps;
|
|
int tckmax_ps;
|
|
|
|
/* SPD-defined CAS latencies */
|
|
unsigned int caslat_x;
|
|
unsigned int caslat_x_minus_1;
|
|
unsigned int caslat_x_minus_2;
|
|
|
|
unsigned int caslat_lowest_derated; /* Derated CAS latency */
|
|
|
|
/* basic timing parameters */
|
|
int trcd_ps;
|
|
int trp_ps;
|
|
int tras_ps;
|
|
|
|
#ifdef CONFIG_SYS_FSL_DDR4
|
|
int trfc1_ps;
|
|
int trfc2_ps;
|
|
int trfc4_ps;
|
|
int trrds_ps;
|
|
int trrdl_ps;
|
|
int tccdl_ps;
|
|
#else
|
|
int twr_ps; /* maximum = 63750 ps */
|
|
int trfc_ps; /* max = 255 ns + 256 ns + .75 ns
|
|
= 511750 ps */
|
|
int trrd_ps; /* maximum = 63750 ps */
|
|
int twtr_ps; /* maximum = 63750 ps */
|
|
int trtp_ps; /* byte 38, spd->trtp */
|
|
#endif
|
|
|
|
int trc_ps; /* maximum = 254 ns + .75 ns = 254750 ps */
|
|
|
|
int refresh_rate_ps;
|
|
int extended_op_srt;
|
|
|
|
#if defined(CONFIG_SYS_FSL_DDR1) || defined(CONFIG_SYS_FSL_DDR2)
|
|
int tis_ps; /* byte 32, spd->ca_setup */
|
|
int tih_ps; /* byte 33, spd->ca_hold */
|
|
int tds_ps; /* byte 34, spd->data_setup */
|
|
int tdh_ps; /* byte 35, spd->data_hold */
|
|
int tdqsq_max_ps; /* byte 44, spd->tdqsq */
|
|
int tqhs_ps; /* byte 45, spd->tqhs */
|
|
#endif
|
|
|
|
/* DDR3 RDIMM */
|
|
unsigned char rcw[16]; /* Register Control Word 0-15 */
|
|
#ifdef CONFIG_SYS_FSL_DDR4
|
|
unsigned int dq_mapping[18];
|
|
unsigned int dq_mapping_ors;
|
|
#endif
|
|
} dimm_params_t;
|
|
|
|
extern unsigned int ddr_compute_dimm_parameters(
|
|
const generic_spd_eeprom_t *spd,
|
|
dimm_params_t *pdimm,
|
|
unsigned int dimm_number);
|
|
|
|
#endif
|