mirror of
https://github.com/u-boot/u-boot.git
synced 2024-12-05 10:33:42 +08:00
16f47c9c51
This patch adds a driver for Renesas SoC's Quad SPI bus. This supports with 8 bits per transfer to use with SPI flash. Signed-off-by: Kouei Abe <kouei.abe.cp@renesas.com> Signed-off-by: Nobuhiro Iwamatsu <nobuhiro.iwamatsu.yj@renesas.com> Signed-off-by: Jagannadha Sutradharudu Teki <jaganna@xilinx.com>
39 lines
1.3 KiB
Plaintext
39 lines
1.3 KiB
Plaintext
-------------------------------------------------
|
|
Simple steps used to test the SH-QSPI at U-Boot
|
|
-------------------------------------------------
|
|
|
|
#0, Currently, SH-QSPI is used by lager board (Renesas ARM SoC R8A7790)
|
|
and koelsch board (Renesas ARM SoC R8A7791). These boot from SPI ROM
|
|
basically. Thus, U-Boot start, SH-QSPI will is operating normally.
|
|
|
|
#1, build U-Boot and load u-boot.bin
|
|
|
|
=> tftpboot 40000000 u-boot.bin
|
|
sh_eth Waiting for PHY auto negotiation to complete.. done
|
|
sh_eth: 100Base/Half
|
|
Using sh_eth device
|
|
TFTP from server 192.168.169.1; our IP address is 192.168.169.79
|
|
Filename 'u-boot.bin'.
|
|
Load address: 0x40000000
|
|
Loading: ############
|
|
2.5 MiB/s
|
|
done
|
|
Bytes transferred = 175364 (2ad04 hex)
|
|
|
|
#2, Commands to erase/write u-boot to flash device
|
|
|
|
Note: This method is description of the lager board. If you want to use the
|
|
other boards, please change the value according to each environment.
|
|
|
|
=> sf probe 0
|
|
SF: Detected S25FL512S_256K with page size 512 Bytes, erase size 64 KiB, total 64 MiB
|
|
=> sf erase 80000 40000
|
|
SF: 262144 bytes @ 0x80000 Erased: OK
|
|
=> sf write 40000000 80000 175364
|
|
SF: 1528676 bytes @ 0x80000 Written: OK
|
|
=>
|
|
|
|
#3, Push reset button.
|
|
|
|
If you're written correctly and driver works properly, U-Boot starts.
|