u-boot/configs/brppt1_spi_defconfig
Tom Rini 10f6e4dc3a Convert CONFIG_SYS_SPL_MALLOC_SIZE et al to Kconfig
This converts the following to Kconfig:
   CONFIG_SYS_SPL_MALLOC_SIZE
   CONFIG_SYS_SPL_MALLOC_START

We introduce a default value here as well, and CONFIG_SYS_SPL_MALLOC to
control if we have a malloc pool or not.

Signed-off-by: Tom Rini <trini@konsulko.com>
2022-06-06 12:09:28 -04:00

130 lines
3.3 KiB
Plaintext

CONFIG_ARM=y
CONFIG_ARCH_OMAP2PLUS=y
CONFIG_SYS_MALLOC_LEN=0x500000
CONFIG_SYS_MALLOC_F_LEN=0x4000
CONFIG_SPL_GPIO=y
CONFIG_SPL_LIBCOMMON_SUPPORT=y
CONFIG_SPL_LIBGENERIC_SUPPORT=y
CONFIG_NR_DRAM_BANKS=1
CONFIG_ENV_SIZE=0x10000
CONFIG_ENV_OFFSET=0x20000
CONFIG_ENV_SECT_SIZE=0x10000
CONFIG_DM_GPIO=y
CONFIG_SPL_DM_SPI=y
CONFIG_DEFAULT_DEVICE_TREE="am335x-brppt1-spi"
CONFIG_AM33XX=y
CONFIG_TARGET_BRPPT1=y
CONFIG_SPL_SERIAL=y
CONFIG_SPL=y
CONFIG_ENV_OFFSET_REDUND=0x30000
CONFIG_SPL_SPI_FLASH_SUPPORT=y
CONFIG_SPL_SPI=y
CONFIG_SYS_LOAD_ADDR=0x80000000
CONFIG_HAS_CUSTOM_SYS_INIT_SP_ADDR=y
CONFIG_CUSTOM_SYS_INIT_SP_ADDR=0x4030ff00
# CONFIG_EXPERT is not set
# CONFIG_FIT is not set
CONFIG_OF_BOARD_SETUP=y
CONFIG_SPI_BOOT=y
CONFIG_BOOTDELAY=0
CONFIG_USE_BOOTCOMMAND=y
CONFIG_BOOTCOMMAND="run b_default"
CONFIG_USE_PREBOOT=y
CONFIG_PREBOOT="run cfgscr; run brdefaultip"
CONFIG_SYS_CONSOLE_IS_IN_ENV=y
CONFIG_SYS_CONSOLE_OVERWRITE_ROUTINE=y
CONFIG_SYS_CONSOLE_INFO_QUIET=y
# CONFIG_DISPLAY_CPUINFO is not set
# CONFIG_DISPLAY_BOARDINFO is not set
CONFIG_ARCH_MISC_INIT=y
CONFIG_SPL_SYS_MALLOC_SIMPLE=y
CONFIG_SYS_SPL_MALLOC=y
CONFIG_SYS_SPL_MALLOC_SIZE=0x500000
# CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR is not set
CONFIG_SPL_I2C=y
# CONFIG_SPL_NAND_SUPPORT is not set
CONFIG_SPL_DM_SPI_FLASH=y
CONFIG_SPL_POWER=y
CONFIG_SPL_SPI_LOAD=y
CONFIG_SYS_SPI_U_BOOT_OFFS=0x40000
CONFIG_SPL_WATCHDOG=y
CONFIG_SPL_YMODEM_SUPPORT=y
CONFIG_HUSH_PARSER=y
CONFIG_SYS_MAXARGS=64
CONFIG_SYS_CBSIZE=512
CONFIG_SYS_PBSIZE=532
CONFIG_CMD_BOOTZ=y
# CONFIG_CMD_IMI is not set
# CONFIG_CMD_XIMG is not set
# CONFIG_CMD_EDITENV is not set
# CONFIG_CMD_CRC32 is not set
# CONFIG_CMD_FLASH is not set
CONFIG_CMD_GPIO=y
CONFIG_CMD_I2C=y
# CONFIG_CMD_LOADS is not set
CONFIG_CMD_MMC=y
CONFIG_CMD_BKOPS_ENABLE=y
CONFIG_CMD_PART=y
CONFIG_CMD_USB=y
# CONFIG_CMD_ITEST is not set
CONFIG_CMD_DHCP=y
CONFIG_BOOTP_MAY_FAIL=y
# CONFIG_CMD_NFS is not set
CONFIG_CMD_MII=y
CONFIG_CMD_PING=y
CONFIG_CMD_BOOTCOUNT=y
CONFIG_CMD_CACHE=y
CONFIG_CMD_TIME=y
CONFIG_CMD_EXT4=y
CONFIG_CMD_EXT4_WRITE=y
CONFIG_CMD_FAT=y
CONFIG_CMD_FS_GENERIC=y
# CONFIG_SPL_DOS_PARTITION is not set
CONFIG_OF_CONTROL=y
CONFIG_SPL_OF_CONTROL=y
CONFIG_OF_SPL_REMOVE_PROPS="pinctrl-0 pinctrl-names clocks clock-names interrupt-parent interrupt-controller interrupt-cells dma-names dmas "
CONFIG_ENV_OVERWRITE=y
CONFIG_ENV_IS_IN_SPI_FLASH=y
CONFIG_SYS_REDUNDAND_ENVIRONMENT=y
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
CONFIG_VERSION_VARIABLE=y
CONFIG_NET_RETRY_COUNT=10
CONFIG_BOOTP_SEND_HOSTNAME=y
CONFIG_NET_RANDOM_ETHADDR=y
CONFIG_NETCONSOLE=y
CONFIG_DM=y
CONFIG_SPL_DM=y
CONFIG_SPL_DM_SEQ_ALIAS=y
# CONFIG_OF_TRANSLATE is not set
CONFIG_BOOTCOUNT_LIMIT=y
CONFIG_DM_I2C=y
CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
CONFIG_MISC=y
CONFIG_MMC_OMAP_HS=y
CONFIG_MTD=y
CONFIG_DM_SPI_FLASH=y
CONFIG_SF_DEFAULT_SPEED=24000000
CONFIG_SPI_FLASH_STMICRO=y
CONFIG_SPI_FLASH_WINBOND=y
# CONFIG_SPI_FLASH_USE_4K_SECTORS is not set
CONFIG_PHY_NATSEMI=y
CONFIG_DM_ETH=y
CONFIG_DRIVER_TI_CPSW=y
CONFIG_DM_PMIC=y
# CONFIG_SPL_DM_PMIC is not set
CONFIG_PMIC_TPS65217=y
CONFIG_DM_SERIAL=y
CONFIG_SPI=y
CONFIG_DM_SPI=y
CONFIG_OMAP3_SPI=y
CONFIG_USB=y
CONFIG_USB_MUSB_HOST=y
CONFIG_USB_MUSB_GADGET=y
CONFIG_USB_MUSB_TI=y
CONFIG_USB_STORAGE=y
CONFIG_USB_GADGET=y
CONFIG_FAT_WRITE=y
CONFIG_LZO=y
# CONFIG_OF_LIBFDT_OVERLAY is not set
# CONFIG_EFI_LOADER is not set