mirror of
https://github.com/u-boot/u-boot.git
synced 2024-12-11 21:53:29 +08:00
7a946961c7
In order for indirect mode on the PIXIS to work properly, both chip selects need to be set to GPCM mode, otherwise writes to the chip select base addresses will not actually post to the local bus -- they'll go to the NAND controller instead. Therefore, we need to set BR0 and BR1 to GPCM mode before switching to indirect mode. Signed-off-by: Timur Tabi <timur@freescale.com> Signed-off-by: Andy Fleming <afleming@freescale.com> |
||
|---|---|---|
| .. | ||
| ddr.c | ||
| diu.c | ||
| law.c | ||
| Makefile | ||
| p1022ds.c | ||
| README | ||
| tlb.c | ||
Overview -------- P1022ds is a Low End Dual core platform supporting the P1022 processor of QorIQ series. P1022 is an e500 based dual core SOC. Pin Multiplex(hwconfig setting) ------------------------------- Add the environment 'usb2', 'audclk' and 'tdm' to support pin multiplex via hwconfig, i.e: 'setenv hwconfig usb2' to enable USB2 and disable eTsec2 'setenv hwconfig tdm' to enable TDM and disable Audio 'setenv hwconfig audclk:12' to enable Audio(codec clock sources is 12MHz) and disable TDM 'setenv hwconfig 'usb2;tdm' to enable USB2 and TDM, disable eTsec2 and Audio 'setenv hwconfig 'usb2;audclk:11' to enable USB2 and Audio(codec clock sources is 11MHz), disable eTsec2 and TDM Warning: TDM and AUDIO can not enable simultaneous ! and AUDIO codec clock sources only setting as 11MHz or 12MHz ! 'setenv hwconfig 'audclk:12;tdm' --- error ! 'setenv hwconfig 'audclk:11;tdm' --- error ! 'setenv hwconfig 'audclk:10' --- error !