mirror of
https://github.com/u-boot/u-boot.git
synced 2024-11-26 05:34:30 +08:00
ee4303cffa
1. The bits 11..10 for mfp driver strength is only valid for aspen and old xscale family, for newer Marvell chip, this range has been moved to 12..11. 2. add sleep bit support Signed-off-by: Xiang Wang <wangx@marvell.com> [robh: rebase to current mainline] Signed-off-by: Rob Herring <robh@kernel.org>
57 lines
1.3 KiB
C
57 lines
1.3 KiB
C
/*
|
|
* (C) Copyright 2010
|
|
* Marvell Semiconductor <www.marvell.com>
|
|
* Written-by: Prafulla Wadaskar <prafulla@marvell.com>,
|
|
*
|
|
* SPDX-License-Identifier: GPL-2.0+
|
|
*/
|
|
|
|
#include <common.h>
|
|
#include <asm/io.h>
|
|
#include <mvmfp.h>
|
|
#include <asm/arch/mfp.h>
|
|
|
|
/*
|
|
* mfp_config
|
|
*
|
|
* On most of Marvell SoCs (ex. ARMADA100) there is Multi-Funtion-Pin
|
|
* configuration registers to configure each GPIO/Function pin on the
|
|
* SoC.
|
|
*
|
|
* This function reads the array of values for
|
|
* MFPR_X registers and programms them into respective
|
|
* Multi-Function Pin registers.
|
|
* It supports - Alternate Function Selection programming.
|
|
*
|
|
* Whereas,
|
|
* The Configureation value is constructed using MFP()
|
|
* array consists of 32bit values as defined in MFP(xx,xx..) macro
|
|
*/
|
|
void mfp_config(u32 *mfp_cfgs)
|
|
{
|
|
u32 *p_mfpr = NULL;
|
|
u32 cfg_val, val;
|
|
|
|
do {
|
|
cfg_val = *mfp_cfgs++;
|
|
/* exit if End of configuration table detected */
|
|
if (cfg_val == MFP_EOC)
|
|
break;
|
|
|
|
p_mfpr = (u32 *)(MV_MFPR_BASE
|
|
+ MFP_REG_GET_OFFSET(cfg_val));
|
|
|
|
/* Write a mfg register as per configuration */
|
|
val = 0;
|
|
if (cfg_val & MFP_VALUE_MASK)
|
|
val |= cfg_val & MFP_VALUE_MASK;
|
|
|
|
writel(val, p_mfpr);
|
|
} while (1);
|
|
/*
|
|
* perform a read-back of any MFPR register to make sure the
|
|
* previous writings are finished
|
|
*/
|
|
readl(p_mfpr);
|
|
}
|