diff --git a/board/st/stm32mp1/stm32mp1.c b/board/st/stm32mp1/stm32mp1.c index 3182f445989..a0a2f9978fd 100644 --- a/board/st/stm32mp1/stm32mp1.c +++ b/board/st/stm32mp1/stm32mp1.c @@ -428,14 +428,11 @@ static int board_check_usb_power(void) static void sysconf_init(void) { -#ifndef CONFIG_TFABOOT u8 *syscfg; -#ifdef CONFIG_DM_REGULATOR struct udevice *pwr_dev; struct udevice *pwr_reg; struct udevice *dev; u32 otp = 0; -#endif int ret; u32 bootr, val; @@ -453,7 +450,6 @@ static void sysconf_init(void) bootr |= (bootr & SYSCFG_BOOTR_BOOT_MASK) << SYSCFG_BOOTR_BOOTPD_SHIFT; writel(bootr, syscfg + SYSCFG_BOOTR); -#ifdef CONFIG_DM_REGULATOR /* High Speed Low Voltage Pad mode Enable for SPI, SDMMC, ETH, QSPI * and TRACE. Needed above ~50MHz and conditioned by AFMUX selection. * The customer will have to disable this for low frequencies @@ -470,7 +466,7 @@ static void sysconf_init(void) ret = uclass_get_device_by_driver(UCLASS_PMIC, DM_GET_DRIVER(stm32mp_pwr_pmic), &pwr_dev); - if (!ret) { + if (!ret && IS_ENABLED(CONFIG_DM_REGULATOR)) { ret = uclass_get_device_by_driver(UCLASS_MISC, DM_GET_DRIVER(stm32mp_bsec), &dev); @@ -507,7 +503,6 @@ static void sysconf_init(void) debug("VDD unknown"); } } -#endif /* activate automatic I/O compensation * warning: need to ensure CSI enabled and ready in clock driver @@ -524,7 +519,6 @@ static void sysconf_init(void) } clrbits_le32(syscfg + SYSCFG_CMPCR, SYSCFG_CMPCR_SW_CTRL); -#endif } #ifdef CONFIG_DM_REGULATOR @@ -647,7 +641,8 @@ int board_init(void) regulators_enable_boot_on(_DEBUG); #endif - sysconf_init(); + if (!IS_ENABLED(CONFIG_TFABOOT)) + sysconf_init(); if (CONFIG_IS_ENABLED(LED)) led_default_state();