tcpdump/slcompress.h
Denis Ovsienko fe3253b9b8 remove tcpdump's own CVS keywords
Remove lots of $Header's and a few $Id's that all belong to the former
CVS repository of tcpdump itself. These keywords have been frozen since
the migration to git in late 2008.
2014-01-03 00:59:08 +04:00

86 lines
3.6 KiB
C

/*
* Definitions for tcp compression routines.
*
* Copyright (c) 1989, 1990, 1992, 1993 Regents of the University of
* California. All rights reserved.
*
* Redistribution and use in source and binary forms are permitted
* provided that the above copyright notice and this paragraph are
* duplicated in all such forms and that any documentation,
* advertising materials, and other materials related to such
* distribution and use acknowledge that the software was developed
* by the University of California, Berkeley. The name of the
* University may not be used to endorse or promote products derived
* from this software without specific prior written permission.
* THIS SOFTWARE IS PROVIDED ``AS IS'' AND WITHOUT ANY EXPRESS OR
* IMPLIED WARRANTIES, INCLUDING, WITHOUT LIMITATION, THE IMPLIED
* WARRANTIES OF MERCHANTIBILITY AND FITNESS FOR A PARTICULAR PURPOSE.
*
* Van Jacobson (van@ee.lbl.gov), Dec 31, 1989:
* - Initial distribution.
*/
/*
* Compressed packet format:
*
* The first octet contains the packet type (top 3 bits), TCP
* 'push' bit, and flags that indicate which of the 4 TCP sequence
* numbers have changed (bottom 5 bits). The next octet is a
* conversation number that associates a saved IP/TCP header with
* the compressed packet. The next two octets are the TCP checksum
* from the original datagram. The next 0 to 15 octets are
* sequence number changes, one change per bit set in the header
* (there may be no changes and there are two special cases where
* the receiver implicitly knows what changed -- see below).
*
* There are 5 numbers which can change (they are always inserted
* in the following order): TCP urgent pointer, window,
* acknowlegement, sequence number and IP ID. (The urgent pointer
* is different from the others in that its value is sent, not the
* change in value.) Since typical use of SLIP links is biased
* toward small packets (see comments on MTU/MSS below), changes
* use a variable length coding with one octet for numbers in the
* range 1 - 255 and 3 octets (0, MSB, LSB) for numbers in the
* range 256 - 65535 or 0. (If the change in sequence number or
* ack is more than 65535, an uncompressed packet is sent.)
*/
/*
* Packet types (must not conflict with IP protocol version)
*
* The top nibble of the first octet is the packet type. There are
* three possible types: IP (not proto TCP or tcp with one of the
* control flags set); uncompressed TCP (a normal IP/TCP packet but
* with the 8-bit protocol field replaced by an 8-bit connection id --
* this type of packet syncs the sender & receiver); and compressed
* TCP (described above).
*
* LSB of 4-bit field is TCP "PUSH" bit (a worthless anachronism) and
* is logically part of the 4-bit "changes" field that follows. Top
* three bits are actual packet type. For backward compatibility
* and in the interest of conserving bits, numbers are chosen so the
* IP protocol version number (4) which normally appears in this nibble
* means "IP packet".
*/
/* packet types */
#define TYPE_IP 0x40
#define TYPE_UNCOMPRESSED_TCP 0x70
#define TYPE_COMPRESSED_TCP 0x80
#define TYPE_ERROR 0x00
/* Bits in first octet of compressed packet */
#define NEW_C 0x40 /* flag bits for what changed in a packet */
#define NEW_I 0x20
#define NEW_S 0x08
#define NEW_A 0x04
#define NEW_W 0x02
#define NEW_U 0x01
/* reserved, special-case values of above */
#define SPECIAL_I (NEW_S|NEW_W|NEW_U) /* echoed interactive traffic */
#define SPECIAL_D (NEW_S|NEW_A|NEW_W|NEW_U) /* unidirectional data */
#define SPECIALS_MASK (NEW_S|NEW_A|NEW_W|NEW_U)
#define TCP_PUSH_BIT 0x10