Factor out the code which checks whenever a usb device is attached
to the port in question. No functional change.
Signed-off-by: Gerd Hoffmann <kraxel@redhat.com>
Rename the function for xhci_port_* naming scheme, also drop
the xhci parameter as port carries a pointer to xhci anyway.
Signed-off-by: Gerd Hoffmann <kraxel@redhat.com>
Add {get,set}_field macros (simliar to ehci) to read and update
some bits of a word. Put them into use for updating pls (port
link state) values. Also add a enum for pls values.
Signed-off-by: Gerd Hoffmann <kraxel@redhat.com>
If the guest uses a TLBWI instruction for upgrading permissions, we
don't need to flush the extra TLBs. This improve boot time performance
by about 10%.
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Use the deposit op instead of and hardcoded bit field insertion. It
allows the host to emit the corresponding instruction if available.
At the same time remove the (lsb > msb) test. The MIPS64R2 instruction
set manual says "Because of the instruction format, lsb can never be
greater than msb, so there is no UNPREDICATABLE case for this
instruction."
(Bug reported as LP:1071149.)
Cc: Никита Канунников <n.kanunnikov@sbtcom.ru>
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
The result of a division by 0, or a division of INT_MIN by -1 in the
signed case, is unpredictable. Just replace 0 by 1 in that case so that
it doesn't trigger a floating point exception on the host.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Avoid the branches in movn/movz implementation and replace them with
movcond. Also update a wrong command.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Store conditional operations only need local temps in user mode. Fix
the code to use temp local only in user mode, this spares two memory
stores in system mode.
At the same time remove a wrong a wrong copied & pasted comment,
store operations don't have a register destination.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Load/store from helpers should be avoided as they are quite
inefficient. Rewrite unaligned loads instructions using TCG and
aligned loads. The number of actual loads operations to implement
an unaligned load instruction is reduced from up to 8 to 1.
Note: As we can't rely on shift by 32 or 64 undefined behaviour,
the code loads already shift by one constants.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
load/store microMIPS helpers are reinventing the wheel. Call do_lw,
do_ll, do_sw and do_sl instead of using a macro calling the cpu_*
load/store functions.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Load/store operations use macros for historical reasons. Now that there
is no point in keeping them, replace them by direct calls to qemu_ld/st.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Rework *raise_exception*() functions so that they can be called from
other helpers, passing the return address as an argument.
Use do_raise_exception() function in update_fcr31() to correctly restore
the CPU state after an FPU exception.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
softfloat already has a few constants defined, use them instead of
redefining them in target-mips.
Rename FLOAT_SNAN32 and FLOAT_SNAN64 to FP_TO_INT32_OVERFLOW and
FP_TO_INT64_OVERFLOW as even if they have the same value, they are
technically different (and defined differently in the MIPS ISA).
Remove the unused constants.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Instead of accessing the flags from the floating point control
register after updating it, read the softfloat flags.
This is just code cleanup and should not change the behaviour.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
For each FPU instruction that can trigger an FPU exception, to call
call update_fcr31() after.
Remove the manual NaN assignment in case of float to float operation, as
softfloat is already taking care of that. However for float to int
operation, the value has to be changed to the MIPS one. In the cvtpw_ps
case, the two registers have to be handled separately to guarantee
a correct final value in both registers.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Instead of clearing the softfloat exception flags before each floating
point instruction, reset them to 0 in update_fcr31() when an exception
is detected.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Use the new softfloat floatXX_muladd() functions to implement the madd,
msub, nmadd and nmsub instructions. At the same time replace the name of
the helpers by the name of the instruction, as the only reason for the
previous names was to keep the macros simple.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Add a pickNaNMulAdd function for MIPS, implementing NaN propagation
rules for MIPS fused multiply-add instructions.
Cc: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
When the CPU state after a possible retranslation is going to be handled
through code retranslation, we don't need to save the CPU state before.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
When the CPU state is restored through retranslation after an exception,
btarget should also be restored.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Commit 9c43b68de6 do not correctly check
for dead outputs when they need to be synced to memory in case of
half-dead operations.
Fix that by applying the same pattern than for the default case.
Tested-by: Stefan Weil <sw@weilnetz.de>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Mark helper functions that raise exceptions, but otherwise do not
change TCG register state, with TCG_CALL_NO_WG.
Signed-off-by: Richard Henderson <rth@twiddle.net>
As the block layer may decide to flush bottom-halfs while the machine is
still initializing (e.g. to read geometry data from the disk), our
postponed open event may be processed before the last frontend
registered with a muxed chardev.
Until the semantics of BHs have been clarified, use an expired timer to
achieve the same effect (suggested by Paolo Bonzini). This requires to
perform the alarm timer initialization earlier as otherwise timer
subsystem can be used before being ready.
Signed-off-by: Jan Kiszka <jan.kiszka@siemens.com>
All switch() decoding instruction have a default entry, so it is possible
to have unused enum entries. Remove conditional definitions of MIPS64
opcode enums, as it only makes the code less readable.
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Add internal functions using by MIPS ASE DSP instructions.
Signed-off-by: Jia Liu <proljc@gmail.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Add missing stubs to win32 to fix link failure.
Signed-off-by: Michael S. Tsirkin <mst@redhat.com>
Reported-by: Paolo Bonzini <pbonzini@redhat.com>
Signed-off-by: Blue Swirl <blauwirbel@gmail.com>
With i386-linux-user target on x86_64 host, this does not introduce any new test
failures.
Signed-off-by: Catalin Patulea <catalinp@google.com>
Signed-off-by: Blue Swirl <blauwirbel@gmail.com>
gcc will silently accept unrecognized -Wno-wombat warning suppression
options (it only mentions them if it has to print a compiler warning
for some other reason). Since we already run a check for whether gcc
recognizes the warning options we use, we can easily make this use
the positive sense of the option when checking for support for the
suppression option. This doesn't have any effect except that it avoids
gcc emitting extra messages about unrecognized command line options
when it is printing other warning messages.
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Stefan Weil <sw@weilnetz.de>
Reviewed-by: Igor Mitsyanko <i.mitsyanko@samsung.com>
Signed-off-by: Blue Swirl <blauwirbel@gmail.com>
There is some read-after-write error within the OP=2 insns which
prevents setting cpu_dst to the real output register. Until this
is found and fixed, always write to a temporary first.
Cc: Blue Swirl <blauwirbel@gmail.com>
Cc: Aurelien Jarno <aurelien@aurel32.net>
Signed-off-by: Richard Henderson <rth@twiddle.net>
Tested-by: Aurelien Jarno <aurelien@aurel32.net>
Signed-off-by: Blue Swirl <blauwirbel@gmail.com>
* 'qspi.2' of git://developer.petalogix.com/public/qemu:
xilinx_zynq: added QSPI controller
xilinx_spips: Generalised to model QSPI
m25p80: Support for Quad SPI
* 's390-for-upstream' of git://repo.or.cz/qemu/agraf:
s390: sclp ascii console support
s390: sclp signal quiesce support
s390: sclp event support
s390: sclp base support
s390: use sync regs for register transfer
s390/kvm_stat: correct sys_perf_event_open syscall number
s390x: fix -initrd in virtio machine
MIPS32 and later instruction sets have a multiplication instruction
directly operating on GPRs. It only produces a 32-bit result but
it is exactly what is needed by QEMU.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
The memory core drops regions that are hidden by another region (for example,
during BAR sizing), but it doesn't do so correctly if the lower address of the
existing range is below the lower address of the new range.
Example (qemu-system-mips -M malta -kernel vmlinux-2.6.32-5-4kc-malta
-append "console=ttyS0" -nographic -vga cirrus):
Existing range: 10000000-107fffff
New range: 100a0000-100bffff
Correct behaviour: drop new range
Incorrect behaviour: add new range
Fix by taking this case into account (previously we only considered
equal lower boundaries).
Tested-by: Aurelien Jarno <aurelien@aurel32.net>
Signed-off-by: Avi Kivity <avi@redhat.com>
Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>
