ath79: add support to TrendNet TEW-673GRU

Add support for the TrendNet TEW-673GRU to ath79.
This device was supported in 19.07.9 but was deprecated with ar71xx.
This is mostly a copy of D-Link DIR-825 B1.
Updates have been completed to enable factory.bin and sysupgrade.bin both.
Code improvements to DTS file and makefile.

Architecture   |  MIPS
Vendor         |  Qualcomm Atheros
bootloader     |  U-Boot
System-On-Chip |  AR7161 rev 2 (MIPS 24Kc V7.4)
CPU/Speed      |  24Kc V7.4 680 MHz
Flash-Chip     |  Macronix MX25L6405D
Flash size     |  8192 KiB
RAM Chip:      |  ProMOS V58C2256164SCI5 × 2
RAM size       |  64 MiB
Wireless       |  2 x Atheros AR922X 2.4GHz/5.0GHz 802.11abgn
Ethernet       |  RealTek RTL8366S Gigabit w/ port based vlan support
USB            |  Yes 2 x 2.0

Initial Flashing Process:
	1) Download 22.03 tew-673gru factory bin
	2) Flash 22.03 using TrendNet GUI

OpenWRT Upgrade Process
	3) Download 22.03 tew-673gru sysupgrade.bin
	4) Flash 22.03 using OpenWRT GUI

Signed-off-by: Korey Caro <korey.caro@gmail.com>
This commit is contained in:
Korey Caro 2022-03-12 23:36:30 -05:00 committed by Hauke Mehrtens
parent 6645a019f8
commit 12cee86989
4 changed files with 204 additions and 4 deletions

View File

@ -0,0 +1,180 @@
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
#include "ar7100.dtsi"
#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>
/ {
compatible = "trendnet,tew-673gru", "qca,ar7161";
model = "TRENDNET TEW-673GRU";
aliases {
led-boot = &led_wps;
led-failsafe = &led_wps;
led-running = &led_wps;
led-upgrade = &led_wps;
};
extosc: ref {
compatible = "fixed-clock";
#clock-cells = <0>;
clock-output-names = "ref";
clock-frequency = <40000000>;
};
leds {
compatible = "gpio-leds";
led_wps: wps {
label = "blue:wps";
gpios = <&gpio 9 GPIO_ACTIVE_LOW>;
};
};
keys {
compatible = "gpio-keys";
reset {
label = "reset";
linux,code = <KEY_RESTART>;
gpios = <&gpio 3 GPIO_ACTIVE_LOW>;
};
wps {
label = "wps";
linux,code = <KEY_WPS_BUTTON>;
gpios = <&gpio 8 GPIO_ACTIVE_LOW>;
};
};
rtl8366s {
compatible = "realtek,rtl8366s";
gpio-sda = <&gpio 5 GPIO_ACTIVE_HIGH>;
gpio-sck = <&gpio 7 GPIO_ACTIVE_HIGH>;
realtek,initvals = <0x06 0x0108>;
mdio-bus {
#address-cells = <1>;
#size-cells = <0>;
status = "okay";
phy4: ethernet-phy@4 {
reg = <4>;
phy-mode = "rgmii";
};
};
};
virtual_flash {
compatible = "mtd-concat";
devices = <&fwconcat0 &fwconcat1>;
partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
partition@0 {
compatible = "denx,uimage";
label = "firmware";
reg = <0x0 0x0>;
};
};
};
};
&usb1 {
status = "okay";
};
&usb2 {
status = "okay";
};
&usb_phy {
status = "okay";
};
&pcie0 {
status = "okay";
wifi@0,11 {
compatible = "pci168c,0029";
reg = <0x8800 0 0 0 0>;
qca,no-eeprom;
};
wifi@0,12 {
compatible = "pci168c,0029";
reg = <0x9000 0 0 0 0>;
qca,no-eeprom;
};
};
&pll {
clocks = <&extosc>;
};
&spi {
status = "okay";
flash@0 {
compatible = "jedec,spi-nor";
reg = <0>;
spi-max-frequency = <25000000>;
partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
partition@0 {
label = "u-boot";
reg = <0x000000 0x040000>;
read-only;
};
partition@40000 {
label = "config";
reg = <0x040000 0x010000>;
read-only;
};
fwconcat0: partition@50000 {
label = "fwconcat0";
reg = <0x050000 0x610000>;
};
partition@660000 {
label = "caldata";
reg = <0x660000 0x010000>;
read-only;
};
fwconcat1: partition@670000 {
label = "fwconcat1";
reg = <0x670000 0x190000>;
};
};
};
};
&eth0 {
status = "okay";
pll-data = <0x11110000 0x00001099 0x00991099>;
fixed-link {
speed = <1000>;
full-duplex;
};
};
&eth1 {
status = "okay";
pll-data = <0x11110000 0x00001099 0x00991099>;
phy-handle = <&phy4>;
};

View File

@ -195,7 +195,8 @@ ath79_setup_interfaces()
;;
buffalo,wzr-hp-g300nh-rb|\
buffalo,wzr-hp-g300nh-s|\
dlink,dir-825-b1)
dlink,dir-825-b1|\
trendnet,tew-673gru)
ucidef_set_interface_wan "eth1"
ucidef_add_switch "switch0" \
"0:lan" "1:lan" "2:lan" "3:lan" "5@eth0"
@ -605,7 +606,8 @@ ath79_setup_macs()
dlink,dap-3662-a1)
label_mac=$(mtd_get_mac_ascii bdcfg "wlanmac")
;;
dlink,dir-825-b1)
dlink,dir-825-b1|\
trendnet,tew-673gru)
lan_mac=$(mtd_get_mac_text "caldata" 0xffa0)
wan_mac=$(mtd_get_mac_text "caldata" 0xffb4)
label_mac=$wan_mac

View File

@ -160,7 +160,8 @@ case "$FIRMWARE" in
netgear,wndap360)
caldata_extract "art" 0x1000 0xeb8
;;
dlink,dir-825-b1)
dlink,dir-825-b1|\
trendnet,tew-673gru)
caldata_extract "caldata" 0x1000 0xeb8
ath9k_patch_mac_crc $(mtd_get_mac_text "caldata" 0xffa0) 0x20c
;;
@ -179,7 +180,8 @@ case "$FIRMWARE" in
netgear,wndap360)
caldata_extract "art" 0x5000 0xeb8
;;
dlink,dir-825-b1)
dlink,dir-825-b1|\
trendnet,tew-673gru)
caldata_extract "caldata" 0x5000 0xeb8
ath9k_patch_mac_crc $(macaddr_add $(mtd_get_mac_text "caldata" 0xffb4) 1) 0x20c
;;

View File

@ -2554,6 +2554,22 @@ define Device/teltonika_rut955-h7v3c0
endef
TARGET_DEVICES += teltonika_rut955-h7v3c0
define Device/trendnet_tew-673gru
SOC := ar7161
DEVICE_VENDOR := Trendnet
DEVICE_MODEL := TEW-673GRU
DEVICE_VARIANT := v1.0R
DEVICE_PACKAGES := -uboot-envtools kmod-usb-ohci kmod-usb2 \
kmod-owl-loader kmod-switch-rtl8366s
IMAGE_SIZE := 7808k
FACTORY_SIZE := 6144k
IMAGES += factory.bin
IMAGE/factory.bin = append-kernel | pad-to $$$$(BLOCKSIZE) | append-rootfs | \
pad-rootfs | check-size $$$$(FACTORY_SIZE) | pad-to $$$$(FACTORY_SIZE) | \
append-string AP94-AR7161-RT-080619-01
endef
TARGET_DEVICES += trendnet_tew-673gru
define Device/trendnet_tew-823dru
SOC := qca9558
DEVICE_VENDOR := Trendnet