mirror of
https://git.busybox.net/buildroot.git
synced 2024-12-04 10:53:30 +08:00
3cc157e2e3
Add a defconfig for the Starfive VisionFive board, a board built around the Starfive JH7100 RISC-V 64bit SoC (same as Beaglev). This board comes with functional lowlevel and U-Boot bootloaders in SPI flash. The defconfig reuses these and only builds a (6.0 based) kernel and rootfs. The factory shipped U-Boot is hard coded to look at MMC partition 3 and misses some variables, so we provide a uEnv.txt to fix that up, based on what is done in provided Fedora image. Signed-off-by: Peter Korsgaard <peter@korsgaard.com> |
||
|---|---|---|
| .. | ||
| overlay/boot | ||
| genimage.cfg | ||
| readme.txt | ||
Starfive VisionFive =================== The VisionFive is a low-cost RISC-V 64-bit based platform, powered by a Starfive JH7100 processor. https://doc-en.rvspace.org/Doc_Center/visionfive.html How to build ============ $ make visionfive_defconfig $ make How to write the SD card ======================== Once the build process is finished you will have an image called "sdcard.img" in the output/images/ directory. Copy the bootable "sdcard.img" onto an SD card with "dd": $ sudo dd if=output/images/sdcard.img of=/dev/sdX Preparing the board =================== Connect a TTL UART cable to pin 6 (GND), 8 (TX) and 10 (RX). Insert your SD card. Power-up the board using an USB-C cable.