mirror of
https://git.busybox.net/buildroot.git
synced 2024-11-24 14:03:29 +08:00
11f869a066
Resurrect support for RIoTboard after 2018.02.x deprecation. Signed-off-by: Nikolay Dimitrov <nikolay.dimitrov@retrohub.org> Signed-off-by: Thomas Petazzoni <thomas.petazzoni@bootlin.com> |
||
|---|---|---|
| .. | ||
| rootfs_overlay/boot/extlinux | ||
| genimage.cfg | ||
| readme.txt | ||
Buildroot for Embest RIoTboard ============================== This is a small development board, based on Freescale IMX6 Solo SoC (single core ARM Cortex-A9). More details about the board can be found at: http://www.embest-tech.com/riotboard 1. Compiling buildroot ---------------------- $ make riotboard_defconfig $ make 2. Installing buildroot ----------------------- Prepare an SD-card and plug it into your card reader. Always double check the block device before writing to it, as writing to the wrong block device can cause irrecoverable data loss. Now you can write the image to your SD-card: sudo dd if=output/images/sdcard.img of=/dev/<sdcard-block-device> bs=1M 3. Running buildroot -------------------- Position the board so you can read the label "RIoTboard" on the right side of SW1 DIP switches. Configure the SW1 swiches like this: 1 0 1 0 0 1 0 1 ON OFF ON OFF OFF ON OFF ON Now plug your prepared SD-card in slot J6. Connect a serial console (115200, 8, N, 1) to header J18. Connect a 5V/1A power supply to the board and enjoy.