mirror of
https://git.busybox.net/buildroot.git
synced 2024-11-23 05:23:39 +08:00
7b02ca842d
Add support for PineCube with: - U-Boot 2022.04 - Linux 5.15.61 PineCube is a low-powered, open source IP camera with the following specs: - Allwinner S3 Cortex-A7 - 128 MiB DDR3 - 16 MiB SPI flash - 5 MPx OV5640 camera - MicroSD slot - 10/100M Ethernet with passive PoE - 802.11 b/g/n WiFi - Bluetooth 4.1 - USB 2.0 - 26 pins GPIO header - Microphone - IR LEDs for night vision Board homepage: https://www.pine64.org/cube/ Board wiki: https://wiki.pine64.org/wiki/PineCube Signed-off-by: Jan Havran <havran.jan@email.cz> Reviewed-by: Giulio Benetti <giulio.benetti@benettiengineering.com> Signed-off-by: Thomas Petazzoni <thomas.petazzoni@bootlin.com> |
||
|---|---|---|
| .. | ||
| extlinux.conf | ||
| genimage.cfg | ||
| post-build.sh | ||
| readme.txt | ||
Intro ===== This directory contains a Buildroot configuration for building a Pine64 PineCube. Board homepage: https://www.pine64.org/cube/ Board wiki: https://wiki.pine64.org/wiki/PineCube How to build it =============== $ make pine64_pinecube_defconfig $ make Note: you will need access to the internet to download the required sources. How to write the SD card ======================== Once the build process is finished you will have an image called "sdcard.img" in the output/images/ directory. Copy the bootable "sdcard.img" onto an SD card with "dd": $ sudo dd if=output/images/sdcard.img of=/dev/sdX $ sudo sync Insert the micro SDcard in your PineCube and power it up. The console is on the serial port 2, 115200 8N1 (check Wiki for board pinout).