buildroot/board/intel/galileo/readme.txt
Ray Kinsella 167cda0fac board: readme.txt for Intel Galileo Gen 1/2
Created a readme.txt for the Intel Galileo Gen 1/2 that describes,

 * How to build for the Intel Galileo Gen 1/2
 * How to access the console on the Intel Galileo Gen 1/2

Signed-off-by: Ray Kinsella <ray.kinsella@intel.com>
Signed-off-by: Thomas Petazzoni <thomas.petazzoni@free-electrons.com>
2015-11-18 21:55:38 +01:00

53 lines
1.2 KiB
Plaintext

Intel Galileo Gen 1/2
Intro
============
These instructions apply to both the Intel Galileo Gen 1/2 development boards
based on the Intel Quark X1000.
How to build
============
Apply the defconfig for the Intel Galileo Gen 1/2
$ make galileo_defconfig
Add any additional packages required and build.
$ make
The build process will create a SD card image and place it in output/images.
$ ls -lh output/images/sdcard.img
-rw-r--r--. 1 foo foo 11M Nov 17 16:19 output/images/sdcard.img
Write the image to an mSD card, insert into the Galileo and power on.
$ dd if=output/images/sdcard.img of=/dev/mmcblk0; sync
Accessing the console
=====================
During power-on the console will become available on the Galileo's ttyS1. This
may be accessed as follows.
* Galileo Gen 1
http://clayskits.com/products/galileo-gen-1-serial-cable
A USB to RS-232 to 3.5mm Jack cable is required. Connect to the 3.5mm
Jack next to the Ethernet Header.
* Galileo Gen 2
http://www.ftdichip.com/Products/Cables/USBTTLSerial.htm
A FTDI TTL-232R-3V3 cable may be used to connect to the FTDI header
next to the Ethernet connector on the Galileo Gen 2.
The console should now be visible at 115200 baud.
$ picocom -b 115200 /dev/ttyUSB0