mirror of
https://git.busybox.net/buildroot.git
synced 2024-11-23 05:23:39 +08:00
5a75e7dbbc
Update linux-3.14.config for Galileo to enable Linux kernel root file system on NFS. Signed-off-by: Bin Meng <bmeng@tinylab.org> Signed-off-by: Thomas Petazzoni <thomas.petazzoni@bootlin.com> |
||
|---|---|---|
| .. | ||
| patches/linux | ||
| rootfs_overlay/etc | ||
| genimage.cfg | ||
| grub.cfg | ||
| linux-3.14.config | ||
| post-build.sh | ||
| post-image.sh | ||
| readme.txt | ||
Intel Galileo Gen 1/2 Intro ============ These instructions apply to both the Intel Galileo Gen 1/2 development boards based on the Intel Quark X1000. How to build ============ Apply the defconfig for the Intel Galileo Gen 1/2 $ make galileo_defconfig Add any additional packages required and build. $ make The build process will create a SD card image and place it in output/images. $ ls -lh output/images/sdcard.img -rw-r--r--. 1 foo foo 11M Nov 17 16:19 output/images/sdcard.img Write the image to an mSD card, insert into the Galileo and power on. $ dd if=output/images/sdcard.img of=/dev/mmcblk0; sync Accessing the console ===================== During power-on the console will become available on the Galileo's ttyS1. This may be accessed as follows. * Galileo Gen 1 http://clayskits.com/products/galileo-gen-1-serial-cable A USB to RS-232 to 3.5mm Jack cable is required. Connect to the 3.5mm Jack next to the Ethernet Header. * Galileo Gen 2 http://www.ftdichip.com/Products/Cables/USBTTLSerial.htm A FTDI TTL-232R-3V3 cable may be used to connect to the FTDI header next to the Ethernet connector on the Galileo Gen 2. The console should now be visible at 115200 baud. $ picocom -b 115200 /dev/ttyUSB0