mirror of
https://mirrors.bfsu.edu.cn/git/linux.git
synced 2024-12-20 09:34:44 +08:00
d491f2b752
If a PCI driver leaves the device handled by it in D0 and calls
pci_save_state() on the device in its ->suspend() or ->suspend_late()
callback, it can expect the device to stay in D0 over the whole
s2idle cycle. However, that may not be the case if there is a
spurious wakeup while the system is suspended, because in that case
pci_pm_suspend_noirq() will run again after pci_pm_resume_noirq()
which calls pci_restore_state(), via pci_pm_default_resume_early(),
so state_saved is cleared and the second iteration of
pci_pm_suspend_noirq() will invoke pci_prepare_to_sleep() which
may change the power state of the device.
To avoid that, add a new internal flag, skip_bus_pm, that will be set
by pci_pm_suspend_noirq() when it runs for the first time during the
given system suspend-resume cycle if the state of the device has
been saved already and the device is still in D0. Setting that flag
will cause the next iterations of pci_pm_suspend_noirq() to set
state_saved for pci_pm_resume_noirq(), so that it always restores the
device state from the originally saved data, and avoid calling
pci_prepare_to_sleep() for the device.
Fixes:
|
||
|---|---|---|
| .. | ||
| controller | ||
| endpoint | ||
| hotplug | ||
| pcie | ||
| switch | ||
| access.c | ||
| ats.c | ||
| bus.c | ||
| ecam.c | ||
| host-bridge.c | ||
| iov.c | ||
| irq.c | ||
| Kconfig | ||
| Makefile | ||
| mmap.c | ||
| msi.c | ||
| of.c | ||
| p2pdma.c | ||
| pci-acpi.c | ||
| pci-bridge-emul.c | ||
| pci-bridge-emul.h | ||
| pci-driver.c | ||
| pci-label.c | ||
| pci-mid.c | ||
| pci-pf-stub.c | ||
| pci-stub.c | ||
| pci-sysfs.c | ||
| pci.c | ||
| pci.h | ||
| probe.c | ||
| proc.c | ||
| quirks.c | ||
| remove.c | ||
| rom.c | ||
| search.c | ||
| setup-bus.c | ||
| setup-irq.c | ||
| setup-res.c | ||
| slot.c | ||
| syscall.c | ||
| vc.c | ||
| vpd.c | ||
| xen-pcifront.c | ||