mirror of
https://mirrors.bfsu.edu.cn/git/linux.git
synced 2024-11-14 15:54:15 +08:00
1253b9b87e
When the clocksource watchdog marks a clock as unstable, this might be due to that clock being unstable or it might be due to delays that happen to occur between the reads of the two clocks. It would be good to have a way of testing the clocksource watchdog's ability to distinguish between these two causes of clock skew and instability. Therefore, provide a new clocksource-wdtest module selected by a new TEST_CLOCKSOURCE_WATCHDOG Kconfig option. This module has a single module parameter named "holdoff" that provides the number of seconds of delay before testing should start, which defaults to zero when built as a module and to 10 seconds when built directly into the kernel. Very large systems that boot slowly may need to increase the value of this module parameter. This module uses hand-crafted clocksource structures to do its testing, thus avoiding messing up timing for the rest of the kernel and for user applications. This module first verifies that the ->uncertainty_margin field of the clocksource structures are set sanely. It then tests the delay-detection capability of the clocksource watchdog, increasing the number of consecutive delays injected, first provoking console messages complaining about the delays and finally forcing a clock-skew event. Unexpected test results cause at least one WARN_ON_ONCE() console splat. If there are no splats, the test has passed. Finally, it fuzzes the value returned from a clocksource to test the clocksource watchdog's ability to detect time skew. This module checks the state of its clocksource after each test, and uses WARN_ON_ONCE() to emit a console splat if there are any failures. This should enable all types of test frameworks to detect any such failures. This facility is intended for diagnostic use only, and should be avoided on production systems. Reported-by: Chris Mason <clm@fb.com> Suggested-by: Thomas Gleixner <tglx@linutronix.de> Signed-off-by: Paul E. McKenney <paulmck@kernel.org> Signed-off-by: Thomas Gleixner <tglx@linutronix.de> Tested-by: Feng Tang <feng.tang@intel.com> Link: https://lore.kernel.org/r/20210527190124.440372-5-paulmck@kernel.org
203 lines
5.8 KiB
C
203 lines
5.8 KiB
C
// SPDX-License-Identifier: GPL-2.0+
|
|
/*
|
|
* Unit test for the clocksource watchdog.
|
|
*
|
|
* Copyright (C) 2021 Facebook, Inc.
|
|
*
|
|
* Author: Paul E. McKenney <paulmck@kernel.org>
|
|
*/
|
|
#define pr_fmt(fmt) KBUILD_MODNAME ": " fmt
|
|
|
|
#include <linux/device.h>
|
|
#include <linux/clocksource.h>
|
|
#include <linux/init.h>
|
|
#include <linux/module.h>
|
|
#include <linux/sched.h> /* for spin_unlock_irq() using preempt_count() m68k */
|
|
#include <linux/tick.h>
|
|
#include <linux/kthread.h>
|
|
#include <linux/delay.h>
|
|
#include <linux/prandom.h>
|
|
#include <linux/cpu.h>
|
|
|
|
MODULE_LICENSE("GPL");
|
|
MODULE_AUTHOR("Paul E. McKenney <paulmck@kernel.org>");
|
|
|
|
static int holdoff = IS_BUILTIN(CONFIG_TEST_CLOCKSOURCE_WATCHDOG) ? 10 : 0;
|
|
module_param(holdoff, int, 0444);
|
|
MODULE_PARM_DESC(holdoff, "Time to wait to start test (s).");
|
|
|
|
/* Watchdog kthread's task_struct pointer for debug purposes. */
|
|
static struct task_struct *wdtest_task;
|
|
|
|
static u64 wdtest_jiffies_read(struct clocksource *cs)
|
|
{
|
|
return (u64)jiffies;
|
|
}
|
|
|
|
/* Assume HZ > 100. */
|
|
#define JIFFIES_SHIFT 8
|
|
|
|
static struct clocksource clocksource_wdtest_jiffies = {
|
|
.name = "wdtest-jiffies",
|
|
.rating = 1, /* lowest valid rating*/
|
|
.uncertainty_margin = TICK_NSEC,
|
|
.read = wdtest_jiffies_read,
|
|
.mask = CLOCKSOURCE_MASK(32),
|
|
.flags = CLOCK_SOURCE_MUST_VERIFY,
|
|
.mult = TICK_NSEC << JIFFIES_SHIFT, /* details above */
|
|
.shift = JIFFIES_SHIFT,
|
|
.max_cycles = 10,
|
|
};
|
|
|
|
static int wdtest_ktime_read_ndelays;
|
|
static bool wdtest_ktime_read_fuzz;
|
|
|
|
static u64 wdtest_ktime_read(struct clocksource *cs)
|
|
{
|
|
int wkrn = READ_ONCE(wdtest_ktime_read_ndelays);
|
|
static int sign = 1;
|
|
u64 ret;
|
|
|
|
if (wkrn) {
|
|
udelay(cs->uncertainty_margin / 250);
|
|
WRITE_ONCE(wdtest_ktime_read_ndelays, wkrn - 1);
|
|
}
|
|
ret = ktime_get_real_fast_ns();
|
|
if (READ_ONCE(wdtest_ktime_read_fuzz)) {
|
|
sign = -sign;
|
|
ret = ret + sign * 100 * NSEC_PER_MSEC;
|
|
}
|
|
return ret;
|
|
}
|
|
|
|
static void wdtest_ktime_cs_mark_unstable(struct clocksource *cs)
|
|
{
|
|
pr_info("--- Marking %s unstable due to clocksource watchdog.\n", cs->name);
|
|
}
|
|
|
|
#define KTIME_FLAGS (CLOCK_SOURCE_IS_CONTINUOUS | \
|
|
CLOCK_SOURCE_VALID_FOR_HRES | \
|
|
CLOCK_SOURCE_MUST_VERIFY | \
|
|
CLOCK_SOURCE_VERIFY_PERCPU)
|
|
|
|
static struct clocksource clocksource_wdtest_ktime = {
|
|
.name = "wdtest-ktime",
|
|
.rating = 300,
|
|
.read = wdtest_ktime_read,
|
|
.mask = CLOCKSOURCE_MASK(64),
|
|
.flags = KTIME_FLAGS,
|
|
.mark_unstable = wdtest_ktime_cs_mark_unstable,
|
|
.list = LIST_HEAD_INIT(clocksource_wdtest_ktime.list),
|
|
};
|
|
|
|
/* Reset the clocksource if needed. */
|
|
static void wdtest_ktime_clocksource_reset(void)
|
|
{
|
|
if (clocksource_wdtest_ktime.flags & CLOCK_SOURCE_UNSTABLE) {
|
|
clocksource_unregister(&clocksource_wdtest_ktime);
|
|
clocksource_wdtest_ktime.flags = KTIME_FLAGS;
|
|
schedule_timeout_uninterruptible(HZ / 10);
|
|
clocksource_register_khz(&clocksource_wdtest_ktime, 1000 * 1000);
|
|
}
|
|
}
|
|
|
|
/* Run the specified series of watchdog tests. */
|
|
static int wdtest_func(void *arg)
|
|
{
|
|
unsigned long j1, j2;
|
|
char *s;
|
|
int i;
|
|
|
|
schedule_timeout_uninterruptible(holdoff * HZ);
|
|
|
|
/*
|
|
* Verify that jiffies-like clocksources get the manually
|
|
* specified uncertainty margin.
|
|
*/
|
|
pr_info("--- Verify jiffies-like uncertainty margin.\n");
|
|
__clocksource_register(&clocksource_wdtest_jiffies);
|
|
WARN_ON_ONCE(clocksource_wdtest_jiffies.uncertainty_margin != TICK_NSEC);
|
|
|
|
j1 = clocksource_wdtest_jiffies.read(&clocksource_wdtest_jiffies);
|
|
schedule_timeout_uninterruptible(HZ);
|
|
j2 = clocksource_wdtest_jiffies.read(&clocksource_wdtest_jiffies);
|
|
WARN_ON_ONCE(j1 == j2);
|
|
|
|
clocksource_unregister(&clocksource_wdtest_jiffies);
|
|
|
|
/*
|
|
* Verify that tsc-like clocksources are assigned a reasonable
|
|
* uncertainty margin.
|
|
*/
|
|
pr_info("--- Verify tsc-like uncertainty margin.\n");
|
|
clocksource_register_khz(&clocksource_wdtest_ktime, 1000 * 1000);
|
|
WARN_ON_ONCE(clocksource_wdtest_ktime.uncertainty_margin < NSEC_PER_USEC);
|
|
|
|
j1 = clocksource_wdtest_ktime.read(&clocksource_wdtest_ktime);
|
|
udelay(1);
|
|
j2 = clocksource_wdtest_ktime.read(&clocksource_wdtest_ktime);
|
|
pr_info("--- tsc-like times: %lu - %lu = %lu.\n", j2, j1, j2 - j1);
|
|
WARN_ON_ONCE(time_before(j2, j1 + NSEC_PER_USEC));
|
|
|
|
/* Verify tsc-like stability with various numbers of errors injected. */
|
|
for (i = 0; i <= max_cswd_read_retries + 1; i++) {
|
|
if (i <= 1 && i < max_cswd_read_retries)
|
|
s = "";
|
|
else if (i <= max_cswd_read_retries)
|
|
s = ", expect message";
|
|
else
|
|
s = ", expect clock skew";
|
|
pr_info("--- Watchdog with %dx error injection, %lu retries%s.\n", i, max_cswd_read_retries, s);
|
|
WRITE_ONCE(wdtest_ktime_read_ndelays, i);
|
|
schedule_timeout_uninterruptible(2 * HZ);
|
|
WARN_ON_ONCE(READ_ONCE(wdtest_ktime_read_ndelays));
|
|
WARN_ON_ONCE((i <= max_cswd_read_retries) !=
|
|
!(clocksource_wdtest_ktime.flags & CLOCK_SOURCE_UNSTABLE));
|
|
wdtest_ktime_clocksource_reset();
|
|
}
|
|
|
|
/* Verify tsc-like stability with clock-value-fuzz error injection. */
|
|
pr_info("--- Watchdog clock-value-fuzz error injection, expect clock skew and per-CPU mismatches.\n");
|
|
WRITE_ONCE(wdtest_ktime_read_fuzz, true);
|
|
schedule_timeout_uninterruptible(2 * HZ);
|
|
WARN_ON_ONCE(!(clocksource_wdtest_ktime.flags & CLOCK_SOURCE_UNSTABLE));
|
|
clocksource_verify_percpu(&clocksource_wdtest_ktime);
|
|
WRITE_ONCE(wdtest_ktime_read_fuzz, false);
|
|
|
|
clocksource_unregister(&clocksource_wdtest_ktime);
|
|
|
|
pr_info("--- Done with test.\n");
|
|
return 0;
|
|
}
|
|
|
|
static void wdtest_print_module_parms(void)
|
|
{
|
|
pr_alert("--- holdoff=%d\n", holdoff);
|
|
}
|
|
|
|
/* Cleanup function. */
|
|
static void clocksource_wdtest_cleanup(void)
|
|
{
|
|
}
|
|
|
|
static int __init clocksource_wdtest_init(void)
|
|
{
|
|
int ret = 0;
|
|
|
|
wdtest_print_module_parms();
|
|
|
|
/* Create watchdog-test task. */
|
|
wdtest_task = kthread_run(wdtest_func, NULL, "wdtest");
|
|
if (IS_ERR(wdtest_task)) {
|
|
ret = PTR_ERR(wdtest_task);
|
|
pr_warn("%s: Failed to create wdtest kthread.\n", __func__);
|
|
wdtest_task = NULL;
|
|
return ret;
|
|
}
|
|
|
|
return 0;
|
|
}
|
|
|
|
module_init(clocksource_wdtest_init);
|
|
module_exit(clocksource_wdtest_cleanup);
|