Roger Quadros f60db98eaa ARM: dts: am57xx-beagle-x15: Add extcon nodes for USB ... On this EVM, the USB cable state has to be determined via the ID pin tied to a GPIO line. We use the gpio-usb-extcon driver to read the ID pin and the extcon framework to forward the USB cable state information to the USB driver so the controller can be configured in the right mode (host/peripheral). NOTE: the ports on this board cannot switch roles. They are configured either host or peripheral by hardwiring the respective ID pins. Signed-off-by: Roger Quadros <rogerq@ti.com> Signed-off-by: Tony Lindgren <tony@atomide.com>		2015-01-30 15:48:39 -08:00
..
bootp	ARM: 8153/1: Enable gcov support on the ARM architecture	2014-09-26 14:39:57 +01:00
compressed	ARM: 8191/1: decompressor: ensure I-side picks up relocated code	2014-11-13 23:45:20 +00:00
dts	ARM: dts: am57xx-beagle-x15: Add extcon nodes for USB	2015-01-30 15:48:39 -08:00
.gitignore
install.sh
Makefile