linux/arch/arm/boot/dts/zynq-zybo-z7.dts
Luis Araneda a2b7baf4ab ARM: dts: zynq: Add LEDs to the Zybo Z7 board
Add an LED node, connected to the Processing System (PS)

Signed-off-by: Luis Araneda <luaraneda@gmail.com>
Signed-off-by: Michal Simek <michal.simek@xilinx.com>
2018-07-19 10:08:51 +02:00

69 lines
1006 B
Plaintext

// SPDX-License-Identifier: GPL-2.0+
/dts-v1/;
#include "zynq-7000.dtsi"
#include <dt-bindings/gpio/gpio.h>
/ {
model = "Digilent Zybo Z7 board";
compatible = "digilent,zynq-zybo-z7", "xlnx,zynq-7000";
aliases {
ethernet0 = &gem0;
serial0 = &uart1;
};
memory@0 {
device_type = "memory";
reg = <0x0 0x40000000>;
};
chosen {
bootargs = "";
stdout-path = "serial0:115200n8";
};
gpio-leds {
compatible = "gpio-leds";
ld4 {
label = "zynq-zybo-z7:green:ld4";
gpios = <&gpio0 7 GPIO_ACTIVE_HIGH>;
};
};
usb_phy0: phy0 {
#phy-cells = <0>;
compatible = "usb-nop-xceiv";
reset-gpios = <&gpio0 46 GPIO_ACTIVE_LOW>;
};
};
&clkc {
ps-clk-frequency = <33333333>;
};
&gem0 {
status = "okay";
phy-mode = "rgmii-id";
phy-handle = <&ethernet_phy>;
ethernet_phy: ethernet-phy@0 {
reg = <0>;
device_type = "ethernet-phy";
};
};
&sdhci0 {
status = "okay";
};
&uart1 {
status = "okay";
};
&usb0 {
status = "okay";
dr_mode = "host";
usb-phy = <&usb_phy0>;
};